Influence of skewed three-dimensional sinusoidal surface roughness on turbulent boundary layers
Open Access
- 1 May 2023
- journal article
- research article
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (5)
Abstract
The impact of roughness skewness (ksk) on turbulent boundary layer (TBL) flow with a zero pressure gradient over three-dimensional (3D) sinusoidal rough surfaces was experimentally investigated using a single hotwire anemometer. Nine 3D sinusoidal profiles were manufactured with positive, negative, and zero roughness skewness values. Measurements were taken at three different freestream velocities for each surface and compared with smooth wall TBL results. This study covered a range of friction Reynolds numbers (Reτ) from approximately 1000 to 4000, with δ/k≈20 ± 2, where δ represents the local boundary layer thickness, and k is the maximum height of the roughness, measured from the valley to peak. The results indicate that the wall-unit normalized streamwise mean velocity profiles for all rough surfaces exhibit a downward shift compared to the smooth wall profiles. Surfaces with positive roughness skewness produced the highest drag, leading to the largest downward shift. The friction coefficient (Cf) decreased as ksk decreased. The percentage increase in Cf and ΔU+ (the roughness function) was much larger when moving from negative to zero roughness skewness than when moving from zero to positive roughness skewness. The small differences in turbulence intensity profiles and higher-order turbulence statistics in the outer region of the TBL support the outer layer similarity hypothesis for the roughness considered in this study. The autocorrelation study revealed that surfaces with positive roughness skewness tend to shorten the average length of turbulence structures in the near-wall region.Keywords
Funding Information
- Australian Research Council
This publication has 39 references indexed in Scilit:
- On the logarithmic region in wall turbulenceJournal of Fluid Mechanics, 2013
- A new formulation for the streamwise turbulence intensity distribution in wall-bounded turbulent flowsEuropean Journal of Mechanics - B/Fluids, 2012
- A new scaling for the streamwise turbulence intensity in wall-bounded turbulent flows and what it tells us about the “outer” peakPhysics of Fluids, 2011
- Use of direct numerical simulation (DNS) data to investigate spatial resolution issues in measurements of wall-bounded turbulenceMeasurement Science and Technology, 2009
- Hot-wire spatial resolution issues in wall-bounded turbulenceJournal of Fluid Mechanics, 2009
- Criteria for assessing experiments in zero pressure gradient boundary layersFluid Dynamics Research, 2009
- The effect of the slope of irregularly distributed roughness elements on turbulent wall-bounded flowsJournal of Fluid Mechanics, 2008
- Evidence of theLaw in a High-Reynolds-Number Turbulent Boundary LayerPhysical Review Letters, 2005
- Structure of transitionally rough and fully rough turbulent boundary layersJournal of Fluid Mechanics, 1986
- The Spectrum of TurbulenceProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1938