Investigation of Mechanical Properties in Layered Multi‐Material 3D Printing Using Commercial Filaments: Direct Stacking of ABS , PA , and Compatibilizing Layers
- 6 December 2025
- journal article
- Published by Wiley in Journal of Vinyl and Additive Technology
- Vol. 32 (2) , 484-498
Abstract
Fused filament fabrication (FFF) technology has rapidly progressed in software and equipment, driven by increasing demand across industries and households. However, the development of compatible and high‐performance materials has lagged, limiting the mechanical integrity and design flexibility of printed components. To address this issue, this study investigates the interfacial bonding behavior of multi‐material structures composed of acrylonitrile butadiene styrene (ABS) and polyamide (PA), two polymers that are chemically incompatible. To enhance interfacial adhesion, three commonly used thermoplastic filaments were employed as intermediate compatibilizing layers. Mechanical characterization was performed through tensile and interlaminar shear strength tests to evaluate bonding performance. All compatibilizing layers improved adhesion between ABS and PA, yielding up to 32% higher tensile strength and 43% higher interlaminar shear strength compared to direct stacking. Fractographic observations confirmed these results by revealing distinct failure patterns and improved interfacial continuity. Overall, the findings demonstrate a practical method for achieving strong adhesion between incompatible polymers without surface treatments or adhesives, offering guidance for the design of hybrid structures and expanding the potential of the technology.Keywords
Funding Information
- Kocaeli Üniversitesi (FHD‐2024‐3631)
This publication has 46 references indexed in Scilit:
- Mechanical properties and predictive analysis of multi‐material polypropylene‐glass fiber sandwich structures produced by material extrusionPolymer Composites, 2025
- Analyzing the Influence of Multimaterial 3D Printing and Postprocessing on Mechanical and Tribological CharacteristicsMacromolecular Materials and Engineering, 2024
- Comprehensive characterization of 3D‐printed bamboo/poly(lactic acid) bio compositesPolymer Engineering & Science, 2023
- Development of sustainable 3D printing filaments using recycled/virgin ABS blends: Processing and characterizationPolymer Engineering & Science, 2023
- Effect of fly ash and coupling agent on the structural, morphological, thermal, and mechanical properties of polyamide 6/acrylonitrile‐butadiene‐styrene blendPolymer Composites, 2021
- Study on performance characteristics of fused deposition modeling 3D‐printed composites by blending and laminationJournal of Applied Polymer Science, 2020
- A novel technique for in‐situ manufacturing of functionally graded materials based polymer composite spur gearsPolymer Composites, 2017
- Essential work of fracture analysis of short glass fiber and/or calcite reinforced ABS/PA6 compositesPolymer Engineering & Science, 2013
- Interaction of thermoplastic polyurethane with polyamide 1212 and its influence on the thermal and mechanical properties of TPU/PA1212 blendsPolymer Engineering & Science, 2007
- Rubber toughening of polyamide 6/organoclay nanocomposites obtained by melt blendingJournal of Applied Polymer Science, 2006