The Combustive Heat of Thirteen Deciduous Wood Species
Open Access
- 3 February 2016
- journal article
- Published by BioResources in BioResources
- Vol. 11 (2) , 4402-4414
Abstract
The heat of combustion relative to the mass, Qm, was evaluated for 13 deciduous wood species, ranging from low to high density. The maximum and minimum values for Qm ranged, respectively, from 19.01 kJ⋅g-1 (Sd = 7 J⋅g-1) to 21.66 kJ⋅g-1 (Sd = 6 J⋅g-1) for Populus tremula and Alnus glutinosa wood. The average value of the Qm for all wood specimens evaluated in the present study was 19.93 kJ⋅g-1 (Sd = 706 J⋅g-1), which is 1.6% higher than the value reported in the literature (Krzysik 1975). A high correlation, R = 0.99, was observed between the volumetric heat of combustion, Qv, and wood density, D0. No correlation was discovered among Qm, D0, the ash content in the wood, ac, as well as the content of the following elements in the ash: calcium (Ca), potassium (K), magnesium (Mg), sodium (Na), silica (Si), aluminum (Al), iron (Fe), copper (Cu), manganese (Mn), sulfur (S), and phosphorus (P).Keywords
This publication has 4 references indexed in Scilit:
- The Combustive Heat of Thirteen Deciduous Wood SpeciesBioResources, 2016
- Calorific value of selected wood species and wood productsEuropean Journal of Wood and Wood Products, 2012
- Are lignocellulosic resources too valuable to burn?BioResources, 2008
- Calculation of gross energy in pet foods: new data on heat combustion and fibre analysis in a selection of foods for dogs and catsJournal of Animal Physiology and Animal Nutrition, 2001