Multi-Objective Optimization of WEDM of Aluminum Hybrid Composites Using AHP and Genetic Algorithm
Open Access
- 7 July 2021
- journal article
- research article
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 47 (7) , 8031-8043
Abstract
Aluminum hybrid composites have the potential to satisfy emerging demands of lightweight materials with enhanced mechanical properties and lower manufacturing costs. There is an inclusion of reinforcing materials with variable concentrations for the preparation of hybrid metal matrix composites to attain customized properties. Hence, it is obligatory to investigate the impact of different machining conditions for the selection of optimum parameter settings for aluminum-based hybrid metal matrix composite material. The present study aims to identify the optimum machining parameters during wire electrical discharge machining of samples prepared with graphite, ferrous oxide, and silicon carbide. In the present research work, five different process parameters and three response parameters such as material removal rate, surface roughness, and spark Gap are considered for process optimization. Energy-dispersive spectroscopy and scanning electron microscopy analysis reported the manifestation of the recast layer. Analytical hierarchy process and genetic algorithm have been successfully implemented to identify the best machining conditions for hybrid composites.Keywords
This publication has 26 references indexed in Scilit:
- Simultaneous optimization of multiple performance characteristics in WEDM for machining ZC63/SiCp MMCAdvances in Manufacturing, 2013
- Friction characteristics of aluminium silicon carbide graphite hybrid compositesMaterials & Design (1980-2015), 2012
- Experimental Investigation and Analysis of Thrust Force in Drilling Hybrid Metal Matrix Composites by Coated Carbide DrillsMaterials and Manufacturing Processes, 2011
- A subjective and objective integrated multiple attribute decision making method for material selectionMaterials & Design (1980-2015), 2010
- Review of research work in sinking EDM and WEDM on metal matrix composite materialsThe International Journal of Advanced Manufacturing Technology, 2010
- Advancing EDM through Fundamental Insight into the ProcessCIRP Annals, 2005
- Recent development in aluminium alloys for aerospace applicationsMaterials Science and Engineering: A, 2000
- Metal matrix composites: production by the stir casting methodJournal of Materials Processing Technology, 1999
- Microstructure evolution during solidification of DRMMCs (Discontinuously reinforced metal matrix composites): State of artJournal of Materials Processing Technology, 1997
- Wire electrical discharge machining of Al2O3 particle and short fibre reinforced aluminium based compositesMaterials Science and Technology, 1996