NOx Pollution Analysis for a Sulfur Recovery Unit Thermal Reactor
Author:
Open Access
- 14 December 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 282 (1) , 012020
Abstract
A sulfur recovery unit (SRU) thermal reactor is the most important equipment in a sulfur plant. It is negatively affected by high temperature operations. In this paper, NOx emissions from the SRU thermal reactors are simulated. Both the prototype thermal reactor and its modifications, including changing fuel mass fraction, changing inlet air quantity, changing inlet oxygen mole fraction, and changing burner geometry, are analyzed to investigate their influences on NOx emissions. In respect of the fuel mass fraction, the simulation results show that the highest NO emission occurs at a zone 1 fuel mass fraction of 0.375, around which the reactor maximum temperature and the zone 1 average temperature reach maximum values. Concerning the inlet air quantity, the highest NO emission occurs when the inlet air quantity is 2.4 times the designed inlet air quantity. This is very close to the inlet air quantity at which the maximum average temperature occurs. Regarding the inlet oxygen mole fraction, the NO emission increases as the inlet oxygen mole fraction increases. With regard to the burner geometry, the NO emission increases as the clearance of the burner acid gas tip increases. In addition, the NO emission increases as the swirling strength increases.Keywords
This publication has 9 references indexed in Scilit:
- Numerical study of the burner parameters on the thermal field in a sulfur recovery unit thermal reactorMATEC Web of Conferences, 2018
- THE EFFECTS OF INLET AIR QUANTITY AND INLET OXYGEN MOLE FRACTION ON THE COMBUSTION AND FLUID FLOW IN A SULFUR RECOVERY UNIT THERMAL REACTORTransactions of the Canadian Society for Mechanical Engineering, 2017
- The Effect of Fuel Mass Fraction on the Combustion and Fluid Flow in a Sulfur Recovery Unit Thermal ReactorApplied Sciences, 2016
- Numerical analysis of the combustion and fluid flow in a carbon monoxide boilerInternational Journal of Heat and Mass Transfer, 2013
- Numerical Study of the Influence of Refractory Thickening on the Reacting Flow and DeNOx Effect in a CO BoilerApplied Mechanics and Materials, 2013
- Emission control of nitrogen oxides in the oxy-fuel processProgress in Energy and Combustion Science, 2009
- Control of combustion-generated nitrogen oxides by selective non-catalytic reductionJournal of Environmental Management, 2007
- Generalized state relationships for scalar properties in nonpremixed hydrocarbon/air flamesCombustion and Flame, 1990
- The numerical computation of turbulent flowsComputer Methods in Applied Mechanics and Engineering, 1974