Large-Area MEMS Tunable Fabry–Perot Filters for Multi/Hyperspectral Infrared Imaging
- 22 December 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Quantum Electronics
- Vol. 23 (2) , 45-52
Abstract
This paper reports on a MEMS tunable Fabry-Perot filter technology capable of achieving nanometer-scale optical flatness across a large mirror area of up to square centimeters without any extraneous stress management techniques. The device employs a single-layer tensile silicon or germanium membrane for the suspended top mirror. Optical characterization of the fabricated single-membrane-based tunable filters for the SWIR, MWIR, and LWIR is presented. The fabricated 1000-μm dimension Si-membrane-based SWIR and MWIR filters are demonstrated with a wavelength tuning range of 1.77-2.42 and 4.1-4.9 μm, respectively, while the fabricated 200-μm-dimension Ge-membrane-based LWIR filter is demonstrated with a wavelength tuning range of 8.5-11.46 μm. All these filters are shown to achieve transmission characteristics that exceed the optical requirements for multispectral imaging applications. A large-area 1-cm dimension Si membrane-based SWIR tunable Fabry-Perot filter for multispectral imaging is demonstrated as a proof-of-concept, showing an excellent surface flatness in the order of 25 nm and an excellent optical uniformity with transmission peak wavelength variability less than 3% across the entire 1-cm dimension optical imaging area. In addition, the optical transmission behavior of the Fabry-Perot filters based on three-layer Si or Ge-based air-spaced DBRs for SWIR, MWIR, and LWIR is modeled, demonstrating that these filters can achieve a fine spectral resolution of several tens of nanometers suitable for hyperspectral imaging applications.Keywords
Funding Information
- Australian Research Council
- Office of Science of the Western Australian State Government
- Western Australian Node of the Australian National Fabrication Facility
- National Collaborative Research Infrastructure Strategy
- Australian researchers
This publication has 17 references indexed in Scilit:
- MEMS-Based Tunable Fabry–Perot Filters for Adaptive Multispectral Thermal ImagingJournal of Microelectromechanical Systems, 2016
- Ge/ZnS-Based Micromachined Fabry–Perot Filters for Optical MEMS in the Longwave InfraredJournal of Microelectromechanical Systems, 2015
- Optimization of ICPCVD Amorphous Silicon for Optical MEMS ApplicationsJournal of Microelectromechanical Systems, 2015
- Widely Tunable MEMS-Based Fabry–Perot FilterJournal of Microelectromechanical Systems, 2009
- MEMS tunable Fabry-Perot Filters with thick, two sided optical coatings2009
- Design and Characterization of Fabry–Pérot MEMS-Based Short-Wave Infrared MicrospectrometersJournal of Electronic Materials, 2008
- Tunable infrared detector with integrated micromachined Fabry-Perot filter2007
- Automated Detection of Chemical Vapors by Pattern Recognition Analysis of Passive Multispectral Infrared Remote Sensing Imaging DataApplied Spectroscopy, 2002
- Multilayer high-reflectance coatings2001
- Evaluation of SO2 emission from Mount Etna using diurnal and nocturnal multispectral IR and visible imaging spectrometer thermal IR remote sensing images and radiative transfer modelsJournal of Geophysical Research, 1999