Hot corrosion resistance of a Ti–Mo–Nb–Al–Si titanium matrix composites reinforced with in-situ TiC prepared by powder metallurgy
- 17 September 2019
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 126510
Abstract
A mixture of the Ti-Mo-Nb-Al-Si matrix powder and Carbon nanotubes (CNTs) particles were used as the raw powder to produce the in-situ TiC reinforced titanium matrix composites (TMCs) via powder metallurgy. The effects of various contents of CNTs on the microstructure, phase composition and hot corrosion behavior of the composites were investigated. The results show that the corrosion mass gain of the composites with CNTs content of 1.0 wt.% was the minimum (18.73 mgcm-2), which was about 44.4% lighter than that of the matrix (33.70 mgcm-2). XRD results show that the corrosion phases were mainly composed of TiO2, Al2O3, SiO2, Ti(SO4)2, NaTiO2 and TiS. According to the SEM results, the grain size of the as-sintered composites can be refined by adding CNTs. With the increase of CNTs content, the grain size became smaller and smaller. The cross-sectional morphology shows that the oxide layer of the composites with 1.0 wt.% CNTs after corrosion was denser and thinner (21.44 μm). It was about 82.13% thinner than the oxide layer of the matrix (120.00 μm). All the results show that the TMCs with 1.0 wt.% CNTs have better hot corrosion resistance.Keywords
Funding Information
- Key Projects of Equipment Pre-research Foundation of the Ministry of Equipment Development of the Central Military Commission of China (614092 2010201)
This publication has 29 references indexed in Scilit:
- Powder route processing of carbon fibres reinforced titanium matrix compositesComposites Science and Technology, 2008
- Microstructural and mechanical characterisation of a Ti6Al4V/TiC/10p composite processed by the BE-CHIP methodComposites Science and Technology, 2005
- Carbon nanotubes: properties and applicationMaterials Science and Engineering: R: Reports, 2004
- Mechanical properties of Ti-6Al-4V/TiB composites with randomly oriented and aligned TiB reinforcementsActa Materialia, 2003
- Microstructural and mechanical characteristics of in situ metal matrix compositesMaterials Science and Engineering: R: Reports, 2000
- Synthesis of near net shape high density TiB/Ti compositeMaterials Science and Engineering: A, 1997
- Exceptionally high Young's modulus observed for individual carbon nanotubesNature, 1996
- In situ technique for synthesizing Fe-TiC compositesScripta Metallurgica et Materialia, 1995
- Effect of carbon sources on the combustion synthesis of TiCJournal of Materials Science, 1995
- Helical microtubules of graphitic carbonNature, 1991