Effect of Leakage Flow Path Wear on Axial Thrust in Downhole Electrical Submersible Pump Unit
- 3 February 2020
- journal article
- research article
- Published by ASME International in Journal of Fluids Engineering
- Vol. 142 (5)
Abstract
Subsea production fluid is quite often characterized by the presence of frac sand, which causes wear within the pump, and alters the performance envelop. One of the design parameters critically affecting reliability is the thrust load generated by an impeller. The change in thrust load due to the erosion of the pump stages is not completely understood, and no relationship exists to foresee these reactive forces due to the complexity involved in predicting the flow characteristics. The purpose of this study is to understand the change in axial thrust due to commonly encountered wear mechanisms across the pump section especially wear across stage clearance seals. Based on in-house erosion testing of a mixed flow pump, three mesh models were built with each representing the pump condition at three different time intervals, namely, 0 h, 52 h, and 117 h of the total test time. The pump numerical models were validated using performance data collected from experimental testing. Axial thrust was found to increase with an increase in wear rate across stage seals. Since the increased clearance causes head degradation as well as an increase in thrust, the relationship of this head degradation is correlated with a change in thrust to further expand the affinity laws.Keywords
This publication has 13 references indexed in Scilit:
- Effect of impeller reflux balance holes on pressure and axial force of centrifugal pumpJournal of Central South University, 2015
- Numerical and Experimental Study of Axial Force and Hydraulic Performance in a Deep-Well Centrifugal Pump With Different Impeller Rear Shroud RadiusJournal of Fluids Engineering, 2013
- Model of Flow in the Side Chambers of an Industrial Centrifugal Pump for Delivering Viscous OilJournal of Fluids Engineering, 2013
- Research on the effect of wear-ring clearances to the performance of centrifugal pumpIOP Conference Series: Earth and Environmental Science, 2012
- An Experimental Study on the Effect of Oil Viscosity and Wear-Ring Clearance on the Performance of an Industrial Centrifugal PumpJournal of Fluids Engineering, 2012
- Method for Analyzing the Performance of Centrifugal Oil PumpsJournal of Fluids Engineering, 2004
- Effect of Reynolds Number and Surface Roughness on the Efficiency of Centrifugal PumpsJournal of Fluids Engineering, 2003
- Hydraulic Axial Thrust in Multistage Pumps—Origins and SolutionsJournal of Fluids Engineering, 2002
- Hydraulic Axial Thrust in Multistage Centrifugal PumpsJournal of Fluids Engineering, 1980
- Axial Hydraulic Thrust Caused by Pump StartingJournal of Basic Engineering, 1972