Preliminary Assessment of Additively Manufactured Cooling Channel Performance for Helium-Cooled Blanket Concepts
- 26 April 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 52 (9) , 3644-3650
Abstract
Sufficient cooling of the blanket first wall remains a critical challenge for the design and deployment of fusion power plants. Helium has been targeted as a potential blanket coolant due to its inertness and low neutron interactivity, among other advantages. However, the low thermal mass of helium creates a need for heat transfer enhancements in coolant channels to provide adequate cooling to the blanket’s first wall. Toward this end, a series of ribbed flow channels of various rib cross sections and configurations has been produced via additive manufacturing (AM) to study the efficacy of AM for first wall heat transfer enhancement and the optimization of heat transfer geometries. Helium cooling performance is studied in AM test articles at 4 MPa operating pressure, Reynolds numbers up to 197 000, and outer surface heat fluxes up to 42 kW/m $^{2}$ in the recently commissioned helium flow loop experiment (HFLE). Preliminary results of this study are presented herein. Heat transfer performance of nominally smooth (i.e., featureless) AM channels is quantified via measured Nusselt numbers and friction factors and compared to off-the-shelf smooth pipe experiments. Results are compared to existing correlations and used to discuss the effects of the AM processes on thermal-hydraulic performance. It is seen that the inherent roughness of the AM channels leads to an increase in both heat transfer coefficient and pressure drop when compared to the conventional pipe. Recommendations are made for future studies based on these findings and additional considerations for the deployment of AM blanket cooling components.Keywords
Funding Information
- UT-Battelle, LLC, with the U.S. Department of Energy (DE-AC05-00OR22725)
- U.S. DOE Fusion Energy Sciences Postdoctoral Research Program administered
- Oak Ridge Institute for Science and Education (ORISE) for the DOE, ORISE is managed
- Oak Ridge Associated Universities (DE-SC0014664)
This publication has 15 references indexed in Scilit:
- Qualification and Commissioning of Helium Flow Loop Experiment for Blanket Design MeasurementsFusion Science and Technology, 2023
- Large Component Simulation of an Inboard Sector of a Dual-Coolant Lead-Lithium BlanketFusion Science and Technology, 2022
- CFD Simulation of Helium Flow Loop Test SectionFusion Science and Technology, 2021
- Heat transfer coefficients of additively manufactured tubes with internal pin fins for supercritical carbon dioxide cycle recuperatorsApplied Thermal Engineering, 2020
- Thermal-hydraulics of helium cooled First Wall channels and scoping investigations on performance improvement by application of ribs and mixing devicesFusion Engineering and Design, 2016
- Scaling Roughness Effects on Pressure Loss and Heat Transfer of Additively Manufactured ChannelsJournal of Turbomachinery, 2016
- The use of water in a fusion power coreFusion Engineering and Design, 2015
- Development of ODS FeCrAl for Compatibility in Fusion and Fission Energy ApplicationsJOM, 2014
- A review study on twisted tape inserts on turbulent flow heat exchangers: The overall enhancement ratio criteriaInternational Communications in Heat and Mass Transfer, 2014
- Neue Gleichungen für den Wärme- und den Stoffübergang in turbulent durchströmten Rohren und KanälenForschung im Ingenieurwesen, 1975