Numerical Simulations of Gas Burner Experiments in a Residential Structure with HVAC System
Open Access
- 17 March 2023
- journal article
- research article
- Published by Springer Nature in Fire Technology
- Vol. 59 (4) , 1489-1517
Abstract
Controlled fire experiments using a gas burner were previously conducted in a purpose-built, two-story, moderately air-tight residential structure to understand the effect of a heating, ventilating, and air conditioning (HVAC) system and door positions on the fire-induced environment. Temperatures, gas concentrations (oxygen, water vapor, carbon dioxide), and differential pressures were monitored throughout the structure. HVAC status (off vs. on) and stairwell door position of the fire room (open vs. closed) were varied for the experiments analyzed in this paper. In this study, Fire Dynamics Simulator (FDS) v. 6.7.9 was used to simulate these experiments. Experimental data quantifying the air tightness of the building and cold flowrates through HVAC vents were determined to be important to optimize leakages and HVAC loss coefficients for the simulation setup. Pressure development in the structure was predicted correctly to be higher on the first floor and lower in the basement, but the magnitude of steady-state pressure was underpredicted. The measured and predicted steady-state temperature distributions were statistically different for the cases with and without the HVAC on, regardless of the door position. FDS predicted gas transport through the HVAC duct network, and under-predicted temperature rise and water vapor content by about 9% and 10%, respectively, and over-predicted volumetric oxygen and carbon dioxide content by about 21% and 6%, respectively. Temperature rise prediction in the closed room, where the gas transport primarily occurred via the HVAC duct network, improved after including heat loss from the HVAC duct to the ambient.Keywords
Funding Information
- Federal Emergency Management Agency (EMW-2017-FP-00 628)
This publication has 16 references indexed in Scilit:
- Test Method for Determining Air Leakage Rate by Fan Pressurization2019
- Coupled hybrid modelling in fire safety engineering; a literature reviewFire Safety Journal, 2018
- Fire-induced pressure and smoke spreading in mechanically ventilated buildings with air-tight envelopesFire Safety Journal, 2017
- Validation of FDS for large-scale well-confined mechanically ventilated fire scenarios with emphasis on predicting ventilation system behaviorFire Safety Journal, 2013
- OECD PRISME project: Fires in confined and ventilated nuclear-type multi-compartments - Overview and main experimental resultsFire Safety Journal, 2013
- Coupling a Network HVAC Model to a Computational Fluid Dynamics Model Using Large Eddy SimulationFire Safety Science, 2011
- Fire dynamics simulator (version 4) :2006
- Fire dynamics simulator (version 4) :2004
- Temperature Uncertainties for Bare-Bead and Aspirated Thermocouple Measurements in Fire Environments2003
- Quantifying fire model evaluation using functional analysisFire Safety Journal, 1999