Elimination of CM Noise from SMPS Circuit using EMI Filter
Open Access
- 26 April 2023
- journal article
- research article
- Published by Faculty of Electrical Engineering, Computer Science and Information Technology Osijek in International journal of electrical and computer engineering systems
- Vol. 14 (4) , 465-471
Abstract
The electronic devices are exposed to external electromagnetic signals that produce an unwanted signal called noise in the circuit, which causes electromagnetic interference [EMI] problems. It occurs in two modes: radiated mode and conducted mode. In the radiation mode, the shielding technique is used for radiation mode, in conduction mode filtering technique is used. The design of an EMI filter depends upon the type of noise generated by the Switched Mode Power supply circuit [SMPS]. The SMPS circuit used in this paper is a DC-DC power converter, the Boost converter is a step-up converter and Buck converter is step down converter are considered as equipment for generation of noise, the Line Impedance Stabilization Network [LISN]is used for generating the common output impedance to the power converters, the EMI filters are designed to eliminate noise generated by the circuits. There noise generated by this power converters is Common Mode [CM] noise and Differential Mode [DM] noise. The separation of noise from the equipment is done by using a noise separator. In this paper, CM noise generated by these power converters is eliminated by designing an EMI filter called an inductor filter and a PI filter. The comparison between the LC inductor filter and the PI filter for the boost and buck converters is observed. The PI filter has better performance characteristics when compared to the inductor filter for both SMPS circuits as per the Comité International Special des Perturbations Radioélectriques [CISPR] standards. This standard gives the conducted emission range for different electronic devices.Keywords
This publication has 10 references indexed in Scilit:
- Design of a Shielded Room against EMP Signal as per MIL-STD 461Engineering, Technology & Applied Science Research, 2023
- Random Valued Impulse Noise Removal Using Region Based Detection ApproachEngineering, Technology & Applied Science Research, 2017
- Analytical Formulation for Shielding Effectiveness of a Lossy Enclosure Containing AperturesIEEE Transactions on Electromagnetic Compatibility, 2017
- Analysis and Design Guide of Active EMI Filter in a Compact Package for Reduction of Common-Mode Conducted EmissionsIEEE Transactions on Electromagnetic Compatibility, 2015
- Suppression of common-mode input electromagnetic interference noise in DC–DC converters using the active filtering methodIET Power Electronics, 2011
- Conducted EMI Mitigation Techniques for Switch-Mode Power Converters: A SurveyIEEE Transactions on Power Electronics, 2010
- ANALYSIS OF SHIELDING EFFECTIVENESS OF SINGLE, DOUBLE AND LAMINATED SHIELDS FOR OBLIQUE INCIDENCE OF EM WAVESProgress In Electromagnetics Research B, 2010
- Investigation of Hybrid EMI Filters for Common-Mode EMI Suppression in a Motor Drive SystemIEEE Transactions on Power Electronics, 2009
- Guideline for a Simplified Differential-Mode EMI Filter DesignIEEE Transactions on Industrial Electronics, 2009
- An Active EMI Filtering Technique for Improving Passive Filter Low-Frequency PerformanceIEEE Transactions on Electromagnetic Compatibility, 2006