Optimized intermediate layer formation and electroless plating methods to obtain supported dense Pd surfaces
Open Access
- 21 February 2024
- journal article
- research article
- Published by The Scientific and Technological Research Council of Turkey (TUBITAK-ULAKBIM) - DIGITAL COMMONS JOURNALS in TURKISH JOURNAL OF CHEMISTRY
- Vol. 48 (1) , 195-209
Abstract
Dense metallic membranes, especially Pd and Pd alloys, have been intensely investigated to provide an alternative and economical way to obtain H2 with ultrahigh purity. To overcome the high cost of Pd, composite membrane structures that comprise a thin layer of Pd are utilized. However, it is a challenge to obtain a thin, dense, and uniform Pd layer on the support materials. This study investigates the parametric analysis of γ-Al2O3 interlayer formation and the electroless Pd plating (Pd ELP) procedures on α-Al2O3 supports with the aim to achieve a thin, uniform Pd surface without annealing. Adjustments in PEG/PVA concentration, dipping time, and heat treatment enabled creating a thin γ-Al2O3 interlayer on α-Al2O3, minimizing pore size and density. Hydrazine concentration, heat treatment, and bath temperature were adjusted to optimize Pd ELP to achieve maximum yield from the plating bath and a dense, uniform surface without annealing. Pd/γ-Al2O3/α-Al2O3 structures were analyzed using scanning electron microscopy, X-ray diffraction, and thermogravimetric analysis to observe the impact of varied parameters on surface structures. Optimized sample was compared to an annealed Pd/α-Al2O3 prepared in accordance with literature methods and a Pd/graphite/α-Al2O3 sample to validate the use of optimized ELP procedure and the γ-Al2O3 interlayer. Results show that a dense and uniform 13 μm Pd coating was achieved on a γ-Al2O3-coated α-Al2O3 support without annealing, using three fresh ELP baths. This was done using sequential hydrazine addition with a decreased concentration (1 M) into the ELP baths at 30 °C, and applying heat treatment at 120 °C between each fresh ELP bath.Keywords
This publication has 46 references indexed in Scilit:
- Electroless Plating of High-Performance Composite Pd Membranes with EDTA-Free BathMaterials, 2021
- Diffraction Crystallite Size Effects on Mechanical Properties of Nanocrystalline (Ti0.8W0.2)CChemistry Africa, 2021
- Alumina double-layered ultrafiltration membranes with enhanced water fluxColloids and Surfaces A: Physicochemical and Engineering Aspects, 2020
- Palladium membranes applications in reaction systems for hydrogen separation and purification: A reviewChemical Engineering and Processing - Process Intensification, 2017
- Abnormal Grain Growth Induced by Cyclic Heat TreatmentScience, 2013
- Self-assembly of boehmite nanopetals to form 3D high surface area nanoarchitecturesApplied Physics A, 2010
- Leak growth mechanism in composite Pd membranes prepared by the electroless deposition methodAIChE Journal, 2007
- Membranes for Hydrogen SeparationChemical Reviews, 2007
- High flux palladium–copper composite membranes for hydrogen separationsDesalination, 2006
- Defect‐free palladium membranes on porous stainless‐steel supportAIChE Journal, 1998