Material Extrusion 3D Printing of Micro-Porous Copper-Based Structure for Water Filters
Open Access
Abstract
This paper presents 3D-printed micro-porous structures made of a Cu/PLA composite by using material extrusion 3D printing technology. A metallic filament made of 80% copper and 20% polylactic acid (PLA) was used for the 3D printing of the porous samples. We varied printing parameters, aiming to obtain a micro-range porosity that can serve as a water-filtering structure. The produced samples were analyzed from the aspects of dimensional accuracy, level of porosity, and capacity for water flow. Several samples were fabricated, and the water flow was exhibited for the samples with an approximate 100 µm size of the interconnected open porosity. The application of material extrusion 3D printing, as a cost-effective, widely available technology for producing micro-range porous structures, is still challenging, especially for interconnected predefined porosity with metal-based filaments. Our research showed that the optimization of 3D printing parameters can enable the fabrication of copper-based micro-porous structures, but further research is still needed.Keywords
Funding Information
- EIT Digital
This publication has 58 references indexed in Scilit:
- Analyzing the Influence of Multimaterial 3D Printing and Postprocessing on Mechanical and Tribological CharacteristicsMacromolecular Materials and Engineering, 2024
- Modification of 3D‐Printed PLA Structures Using Photo‐Iniferter Polymerization: Toward On‐Demand Antimicrobial Water FiltersMacromolecular Rapid Communications, 2023
- 3D Printed Micro‐Electrochemical Energy Storage DevicesBatteries & Supercaps, 2023
- Targeted Additive Micromodulation of Grain Size in Nanocrystalline Copper Nanostructures by Electrohydrodynamic Redox 3D PrintingSmall, 2022
- Property enhancement approaches of fused filament fabrication technology: A reviewPolymer Engineering & Science, 2022
- Post‐processing technologies of copper–polylactic acid composites obtained by 3D printing fused deposition modelingMaterial Design & Processing Communications, 2021
- 3D printed PLA/copper bowtie antenna for biomedical imaging applicationsPhysical and Engineering Sciences in Medicine, 2020
- 3D printing of copper particles and poly(methyl methacrylate) beads containing poly(lactic acid) composites for enhancing thermomechanical propertiesJournal of Applied Polymer Science, 2020
- Hybrid Manufacturing and Mechanical Characterization of Cu/PLA CompositesArabian Journal for Science and Engineering, 2020
- Production and characterization of a hybrid polymer matrix compositePolymer Composites, 2017