Targeted Additive Micromodulation of Grain Size in Nanocrystalline Copper Nanostructures by Electrohydrodynamic Redox 3D Printing
Open Access
Abstract
The control of materials’ microstructure is both a necessity and an opportunity for micro/nanometer‐scale additive manufacturing technologies. On the one hand, optimization of purity and defect density of printed metals is a prerequisite for their application in microfabrication. On the other hand, the additive approach to materials deposition with highest spatial resolution offers unique opportunities for the fabrication of materials with complex, 3D graded composition or microstructure. As a first step toward both—optimization of properties and site‐specific tuning of microstructure—an overview of the wide range of microstructure accessed in pure copper (up to >99.9 at.%) by electrohydrodynamic redox 3D printing is presented, and on‐the‐fly modulation of grain size in copper with smallest segments ≈400 nm in length is shown. Control of microstructure and materials properties by in situ adjustment of the printing voltage is demonstrated by variation of grain size by one order of magnitude and corresponding compression strength by a factor of two. Based on transmission electron microscopy and atom probe tomography, it is suggested that the small grain size is a direct consequence of intermittent solvent drying at the growth interface at low printing voltages, while larger grains are enabled by the permanent presence of solvent at higher potentials.Keywords
Funding Information
- Schweizerischer Nationalfonds zur Förderung der Wissenschaftlichen Forschung (200021_188491)
This publication has 54 references indexed in Scilit:
- Variable property rapid prototypingVirtual and Physical Prototyping, 2011
- Nanoporous gold: a new material for catalytic and sensor applicationsPhysical Chemistry Chemical Physics, 2010
- Meniscus-Confined Three-Dimensional Electrodeposition for Direct Writing of Wire BondsScience, 2010
- Ultratough nanocrystalline copper with a narrow grain size distributionApplied Physics Letters, 2004
- Ultrahigh Strength and High Electrical Conductivity in CopperScience, 2004
- Microstructural evolution, microhardness and thermal stability of HPT-processed CuMaterials Science and Engineering: A, 2000
- Deformation behaviour of ultra-fine-grained copperActa Metallurgica et Materialia, 1994
- Some fundamental aspects of levelling and brightening in metal electrodepositionJournal of Applied Electrochemistry, 1991
- Surface self‐diffusion measurements on copperPhysica Status Solidi (b), 1968
- The relation between load and penetration in the axisymmetric boussinesq problem for a punch of arbitrary profileInternational Journal of Engineering Science, 1965