Add-On Microchannels for Hotspot Thermal Management of Microelectronic Chips in Compact Applications
- 8 October 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 9 (3) , 434-445
Abstract
This work demonstrates an experimental microchannel solution to cool microelectronic chips with hot spots, using an integrated, yet non-intrusive technique. In microelectronics, approaches such as die thinning induce acute stress on cooling because it increases the hot spot phenomena and reduces chip bulk thickness that could be used for microchannels. In compact devices, heat must be removed using limited pumping power and cooling space. Microchannels etched in the backside of the chip, usually considered as an efficient cooling solution, are impracticable on highly thinned chips. This work experimentally investigates the cooling performance of a non-invasive and hot spot aware microchannel die that is in direct fluidic contact with the backside of the microelectronic chip. It also proposes a confinement-wise metric. A thermal resistance of 2.8 °C/W is achieved at a heat flux of 812 W/cm2 per heat source, for a total dissipated power of 20 W and a maximum allowed temperature rise of 55 °C. Such performance is obtained with only 19.2 kPa of pressure drop and 9.4 ml/min of flow rate, corresponding to a hydraulic power of only 3 mW and a coefficient of performance of 6 500. In addition, the complete chip stack, including the thinned chip, measures only 660 μm high. Therefore, backside cooling appears to be a promising compact and low consumption solution for compact electronic applications having confined hot spots.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
- Centre National de la Recherche Scientifique (ANR-10-AIRT-05, ANRT CIFRE)
- Fonds de recherche du Quebec—Nature et Technologie
This publication has 26 references indexed in Scilit:
- Fine-tuning width and aspect ratio of an improved microchannel heat sink for energy-efficient thermal managementEnergy Conversion and Management, 2015
- Experimental and numerical study of fluid flow and heat transfer characteristics in microchannel heat sink with complex structureEnergy Conversion and Management, 2015
- A novel method of energy efficient hotspot-targeted embedded liquid cooling for electronics: An experimental studyInternational Journal of Heat and Mass Transfer, 2015
- Stepwise varying width microchannel cooling device for uniform wall temperature: Experimental and numerical studyApplied Thermal Engineering, 2015
- A review of heat transfer and pressure drop characteristics of single and two-phase microchannelsInternational Journal of Heat and Mass Transfer, 2014
- Experimental and analytical study on chip hot spot temperatureInternational Journal of Heat and Mass Transfer, 2011
- Experimental Investigation of an Ultrathin Manifold Microchannel Heat Sink for Liquid-Cooled ChipsJournal of Heat Transfer, 2010
- Experimental and Numerical Study of a Stacked Microchannel Heat Sink for Liquid Cooling of Microelectronic DevicesJournal of Heat Transfer, 2007
- Nano and Micro Technology-Based Next-Generation Package-Level Cooling SolutionsIntel Technology Journal, 2005
- Improved International Formulations for the Viscosity and Thermal Conductivity of Water SubstanceJournal of Physical and Chemical Reference Data, 1986