Effects of Manganese on Microstructure and Work-hardening Behavior of Low-carbon Lath Martensitic Steel
Open Access
- 15 February 2025
- journal article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 65 (2) , 274-283
Abstract
Microstructures of lath martensite have been studied intensively to understand their effect on the mechanical properties of steels. It is, however, said that the relation between microstructural factors and mechanical properties has not been clarified yet. The plastic deformation behavior of fully lath martensitic steels has become important because they are applied to automobile body structures such as bumper reinforcement. It is, therefore, important to understand the microstructural factors that control the work-hardening behavior of fully martensitic steels. Although we could not clarify differences in microstructural factors when manganese (Mn) concentrations of steels are altered, the work-hardening of 8 mass%Mn martensitic steel is much higher than that of 5 mass%Mn martensitic steel. It was found using the digital image correlation (DIC) method, that the strain concentration due to the in-lath-plane slip deformation is more developed in 5 mass%Mn martensitic steel than 8 mass%Mn martensitic steel. Transmission electron microscope (TEM) observations revealed the existence of two types of fine twins inside laths. Long twins that are parallel to the longitude of the lath are observed both in 5 mass%Mn and 8 mass%Mn martensitic steels. Short twins that partially cross the laths, on the other hand, can only be found in 8 mass%Mn martensitic steel. Since twin boundaries are high angle boundaries, the short twins are supposed to prevent the development of in-lath-plane slip deformation. This seems to be the mechanism of higher work-hardening behavior observed in 8 mass%Mn martensitic steel.Keywords
This publication has 30 references indexed in Scilit:
- Effect of carbon content on selection of slip system during uniaxial tensile deformation of lath martensiteMaterials Science and Engineering: A, 2020
- Lath formation mechanisms and twinning as lath martensite substructures in an ultra low-carbon iron alloyScientific Reports, 2018
- Nanoclusters of α-Fe naturally formed in twinned martensite after martensitic transformationJournal of Applied Physics, 2018
- Work Hardening, Dislocation Structure, and Load Partitioning in Lath Martensite Determined by In Situ Neutron Diffraction Line Profile AnalysisMetallurgical and Materials Transactions A, 2017
- Multiple mechanisms of lath martensite plasticityActa Materialia, 2016
- Composite Behavior of Lath Martensite Steels Induced by Plastic Strain, a New Paradigm for the Elastic-Plastic Response of Martensitic SteelsMetallurgical and Materials Transactions A, 2016
- The morphology and crystallography of lath martensite in alloy steelsActa Materialia, 2006
- The morphology and crystallography of lath martensite in Fe-C alloysActa Materialia, 2003
- Martensite in steel: strength and structureMaterials Science and Engineering: A, 1999
- On the morphology and substructure of martensiteMetallurgical Transactions, 1970