Characteristics of AISi10Mg Aluminum Alloy Plates Produced Through Additive Manufacturing Technique
- 1 January 2025
- journal article
- Published by Firat Universitesi in Turkish Journal of Science and Technology
- Vol. 20 (2) , 495-505
Abstract
TThe microstructure and mechanical properties of AlSi10Mg aluminum alloy sheets produced by additive manufacturing method were revealed. It was clearly observed that the microstructure consisted of weld pools separated by boundaries. Furthermore, a small number of distributed pores with diameters ranging from 35 µm to 5 µm were detected in the microstructure. A few small-sized pores are a sign of good production. Vickers microhardness of the produced AlSi10Mg alloy was measured to be average 126.625 HV. Additionally, its tensile strength and three-point bending strength value were found to be 433 MPa and 548 MPa, respectively. The tensile fracture surface had many small and deep dimples while three-point bending fracture surface also possessed dimples, however, bigger and shallower compared with that of tensile fracture. Therefore, the tensile and three-point bending tests showed a reasonable ductile fracture behavior.Keywords
This publication has 44 references indexed in Scilit:
- Mechanical performance optimization in FFF 3D printing using Taguchi design and machine learning approach with PLA /walnut Shell composites filamentsJournal of Vinyl and Additive Technology, 2025
- Anisotropic and high-temperature deformation behavior of additively manufactured AlSi10Mg: Experiments and microscale modelingAdditive Manufacturing, 2024
- Improved Ductility by Reducing Powder Size in Laser Powder Bed Fusion of AlSi10MgAdditive Manufacturing Frontiers, 2024
- Effect of rolling deformation and passes on microstructure and mechanical properties of 7075 aluminum alloyCeramics International, 2022
- High-temperature mechanical properties of AlSi10Mg specimens fabricated by additive manufacturing using selective laser melting technologies (AM-SLM)Additive Manufacturing, 2018
- Joining of 3D-printed AlSi10Mg by friction stir weldingWelding in the World, 2018
- Prediction of lack-of-fusion porosity for powder bed fusionAdditive Manufacturing, 2017
- Additive manufacturing of metalsActa Materialia, 2016
- Additive manufacturing methods and modelling approaches: a critical reviewThe International Journal of Advanced Manufacturing Technology, 2015
- Metal Additive Manufacturing: A ReviewJournal of Materials Engineering and Performance, 2014