Methanol With Increased Water Content in Internal Combustion Engines
Open Access
- 2 September 2026
- journal article
- Published by Wiley in Chemie Ingenieur Technik
Abstract
This paper shows the advantages of methanol as a fuel and compares pure methanol (>99.9%) and methanol with a high‐water content (>18%) for use in an internal combustion engine. 18% water content is representative for methanol synthesized from hydrogen and industrial furnace gases as a carbon dioxide source. The achievable best point indicated efficiency is higher than 43% for both fuels. The increased water content of the low‐purity methanol is compensated by a longer injection time and can approximately be compared to a constant exhaust gas recirculation, which cannot be adjusted to the operating condition. Therefore, the best efficiency operation points are limited to a middle engine speed range and high load, which perfectly fits to a serial hybrid powertrain topology (Range Extender). The paper shows that additional energy that may be required for methanol distillation to high purity can be saved without losing combustion efficiency.Keywords
Funding Information
- Bundesministerium für Forschung und Technologie (03SF0789C)
- Bundesministerium für Forschung und Technologie (03EW0019C)
This publication has 4 references indexed in Scilit:
- Methanol Cold Start Procedure for a Serial Hybrid PowertrainSAE International Journal of Advances and Current Practices in Mobility, 2025
- Methanol, the ICE Green MakerChemie Ingenieur Technik, 2024
- Methanol Synthesis from Sustainable Feedstocks – A Quantitative Side Product AnalysisChemie Ingenieur Technik, 2024
- Simulation of Methanol and Urea Production from Catalytic Conversion of Steel Mill GasesChemie Ingenieur Technik, 2020