Mixture Preparation and Combustion Variability in a Spray-Guided DISI Engine
Authors:
Open Access
- 29 October 2007
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
In an attempt to study the numerous contributors towards cyclic variations in combustion in a direct injection spark ignition engine, simultaneous high-speed imaging of fuel injection and flame growth are undertaken on a crank-angle resolved basis in a single-cylinder optical research engine. Batches of images from 100 consecutive cycles are acquired for all conditions with synchronised in-cylinder pressure logging. The engine is motored and fired at stoichiometric conditions at 1500 RPM under part-load and wide-open-throttle conditions (0.5-1.0 bar intake pressure), with injection timing set early in the intake stroke to promote homogeneous mixture formation with a centrally mounted multi-hole injector. Liquid impingement is observed on the cylinder walls and on the piston crown with early intake injection and multiple injection strategies are employed in an attempt to reduce impingement and alter mixture preparation and subsequent combustion. The effects are investigated for iso-octane and pump-grade gasoline at engine coolant temperatures of 50 and 90 °C. Gasoline sprays showed severe deformation and partial collapse of the individual spray plumes at 90 °C, leading to a different mixture formation process relative to iso-octane, which showed no such effects at this engine temperature. Using multiple fuel injections per cycle, but maintaining the same overall air-to-fuel ratio with single-injection strategies, a significant reduction in direct impingement on the walls was observed, together with different flame growth relative to single injection. These results suggest that injection strategy and type of fuel is playing an important role in the mixture preparation process, even for homogeneous early direct injection, and that different types of multiple-injection strategies alone have the potential to modify significantly in-cylinder phenomena, affect combustion and potentially exhaust emissions.Keywords
This publication has 27 references indexed in Scilit:
- A Multi-Variable High-Speed Imaging Study of Ignition Instabilities in a Spray-Guided Direct-Injected Spark-Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 2006
- The HOTFIRE Homogeneous GDI and Fully Variable Valve Train Project - An Initial ReportSAE International Journal of Advances and Current Practices in Mobility, 2006
- Quantitative Analysis of Mixture Preparation Processes in New Direct-Injection Spark Ignition EnginesJSME International Journal Series B, 2005
- The relative effects of fuel concentration, residual-gas fraction, gas motion, spark energy and heat losses to the electrodes on flame-kernel development in a lean-burn spark ignition engineProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2004
- The nature of early flame development in a lean-burn stratified-charge spark-ignition engineCombustion and Flame, 2004
- Flame chemiluminescence studies of cyclic combustion variations and air-to-fuel ratio of the reacting mixture in a lean-burn stratified-charge spark-ignition engineCombustion and Flame, 2004
- Analysis of cycle-by-cycle variation in a direct injection gasoline engine using a laser-induced fluorescence techniqueInternational Journal of Engine Research, 2003
- Use of Advanced Tools for the Analysis of Gasoline Direct Injection EnginesOil & Gas Science and Technology – Revue d’IFP Energies nouvelles, 2003
- Cyclic Variations of Initial Flame Kernel Growth in a Honda VTEC-E Lean-Burn Spark-Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 2000
- Cyclic Variability in Spark Ignition Engines A Literature SurveySAE International Journal of Advances and Current Practices in Mobility, 1994