Distortion Minimization for Packaging Level Interconnects
- 1 October 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21654107,p. 175-178
Abstract
We propose a novel high-speed serial signaling scheme that minimizes the distortion for multichip module (MCM) packaging level communication by intentionally adding leakage resistors between the signal trace and the ground. The new scheme is inspired by the theory of distortionless transmission line which states that if R/G = L/C, there will be no distortion at the receiver end and the signal propagates at the speed of light. The simulation results indicate that, using the shunt resistor scheme, 10+ Gbps bit rate is achievable over a 10 cm single-ended stripline without pre-emphasis or equalizationKeywords
This publication has 7 references indexed in Scilit:
- Design guideline for resistive termination of on-chip high-speed interconnects2006
- Performance prediction of on-chip high-throughput global signaling2006
- Global signaling over lossy transmission lines2005
- On-chip global signaling by wave pipelining2005
- Performance limitation of on-chip global interconnects for high-speed signaling2004
- Characterization of Liquid Crystal Polymer (LCP) Material and Transmission Lines on LCP Substrates From 30 to 110 GHzIEEE Transactions on Microwave Theory and Techniques, 2004
- Thin-film multichip module packages for high-end IBM serversIBM Journal of Research and Development, 1998