Hongyu Chen
Hongyu Chen has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Alina Deutsch
IBM T.J. Watson Research Center, Yorktown Heights, NY 10598
1 shared publication- Chung-Kuan Cheng
CSE Dept., Univ. of California San Diego, 9500 Gilman Drive, La Jolla, CA 92093-0404. Tel: 1-858-534-8174, Fax: 1-858-534-7029
1 shared publication George Katopis
IBM Enterprise System Group, Poughkeepsie, NY 12601
1 shared publication- Haikun Zhu
CSE Dept., Univ. of California San Diego, 9500 Gilman Drive, La Jolla, CA 92093-0404. Tel: 1-858-534-8174, Fax: 1-858-534-7029
1 shared publication - Rui Shi
CSE Dept., UCSD, La Jolla, CA 92093-0404, USA
1 shared publication
Latest Publications
- 1 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21654107,p. 175-178
Distortion Minimization for Packaging Level Interconnects
We propose a novel high-speed serial signaling scheme that minimizes the distortion for multichip module (MCM) packaging level communication by intentionally adding leakage resistors between the signal trace and the ground. The new scheme is inspired by the theory of distortionless transmission line which states that if R/G = L/C, there will be no distortion at the receiver end and the signal propagates at the speed of light. The simulation results indicate that, using the shunt resistor scheme, 10+ Gbps bit rate is achievable over a 10 cm single-ended stripline without pre-emphasis or equalization
- 1 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21654107,p. 175-178
Distortion Minimization for Packaging Level Interconnects
We propose a novel high-speed serial signaling scheme that minimizes the distortion for multichip module (MCM) packaging level communication by intentionally adding leakage resistors between the signal trace and the ground. The new scheme is inspired by the theory of distortionless transmission line which states that if R/G = L/C, there will be no distortion at the receiver end and the signal propagates at the speed of light. The simulation results indicate that, using the shunt resistor scheme, 10+ Gbps bit rate is achievable over a 10 cm single-ended stripline without pre-emphasis or equalization