Vacuum-Assisted Hot-Forming Using Tailored Laminate Temperature
Open Access
- 20 January 2021
- journal article
- research article
- Published by Springer Nature in Applied Composite Materials
- Vol. 28 (2) , 247-269
Abstract
A non-isothermal vacuum assisted hot-forming process using tailored laminate temperature is introduced. By using process simulation and manufacturing experiments, improved laminate quality is achieved compared to the standard hot-forming process. Furthermore, it is also shown that the manufacturing time in the clean room can be reduced to one tenth of the standard process time. In this study 8.4 mm thick quasi-isotropic laminates from unidirectional prepreg were laid up flat with an automatic tape laying machine and hot-formed to a U-shaped laminate. The laminates were then cured in a concave mould with standard bag on the inside. A complete tailored temperature hot-forming cycle of 7.5 min produced a very good final laminate quality with a total thickness variation as low as 4.0% and without wrinkles or indications of porosity. With a 4 min hot-forming cycle the thickness variation was also acceptable at 8%.Keywords
Funding Information
- Royal Institute of Technology
This publication has 18 references indexed in Scilit:
- Contribution of processing parameters on void content in the vacuum bagging configurations of L-shaped composite laminatesThe International Journal of Advanced Manufacturing Technology, 2017
- A review on the manufacturing defects of complex-shaped laminate in aircraft composite structuresThe International Journal of Advanced Manufacturing Technology, 2017
- Review of thermal conductivity in composites: Mechanisms, parameters and theoryProgress in Polymer Science, 2016
- Defect reduction strategies for the manufacture of contoured laminates using vacuum BAG‐only prepregsPolymer Composites, 2015
- Out-of-plane ply wrinkling defects during consolidation over an external radiusComposites Science and Technology, 2014
- Effect of forming temperature on the quality of hot diaphragm formed C-shaped thermosetting composite laminatesJournal of Reinforced Plastics and Composites, 2012
- Experimental and numerical study of the effect of caul-sheets on corner thinning of composite laminatesComposites Part A: Applied Science and Manufacturing, 2002
- Mechanisms of wrinkle formation during the processing of composite laminatesComposites Science and Technology, 1999
- Transverse thermal conductance of thermosetting composite materials during their cureJournal of Thermophysics and Heat Transfer, 1994
- Estimation of Thermal Properties in Carbon/Epoxy Composite Materials during CuringJournal of Composite Materials, 1992