Ringing Suppression in a Controller Area Network With Flexible Data Rate Using Frequency-Selective Impedance Matching and Temporal Impedance Switching
- 30 May 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. 71 (9) , 9375-9383
Abstract
An inherent impedance mismatch in a controller area network with flexible data rate (CAN-FD) network gives rise to signal distortion called ringing. Ringing is one of the main causes of communication errors and performance degradation. In this paper, a ringing suppression system is proposed, which alleviates the impedance mismatch at two mismatch locations: the unterminated CAN nodes and the divergence points of bus lines. At the unterminated CAN nodes, a temporal impedance switching circuit, including a matching resistor and a limiting diode, is added. The circuit is controlled to only engage right after a dominant-to-recessive transition when ringing likely occurs. At the divergence points, a frequency-selective impedance matching circuit is inserted. The circuit consists of a resistor, a capacitor, and an inductor connected in parallel, which is also designed to activate only during state transitions with the dependency of their impedance on frequency. Thus, the side effects on CAN-FD operations can be prevented. The performance of the ringing suppression system is verified by experiments. The experimental results demonstrate that the proposed system reduces ringing to a level lower than the input threshold for recessive bit detection in diverse bus configurations and supports more reliable CAN-FD communication.Keywords
Funding Information
- Kwangwoon University (research grant)
This publication has 19 references indexed in Scilit:
- Analytical and Experimental Performance Evaluations of CAN-FD BusIEEE Access, 2018
- A Quantitative Performance Study on CAN and CAN FD Vehicular NetworksIEEE Transactions on Industrial Electronics, 2017
- High-Speed CAN (HSC) for Vehicle Applications at 500 KBPS2017
- CAN FD: Performance reality2017
- An Adaptive Impedance-Matching System for Vehicular Power Line CommunicationIEEE Transactions on Vehicular Technology, 2016
- CAN FD Network Design Hints and RecommendationsSAE International Journal of Passenger Cars - Electronic and Electrical Systems, 2016
- Passive filter design supporting a star-like joint-connector-based topology in high-speed controller area networksProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2013
- A Multidrop Bus Design Scheme With Resistor-Based Impedance Matching on Nonuniform Impedance LinesIEEE Transactions on Circuits and Systems I: Regular Papers, 2010
- A Low-Cost Resonance Mitigation Technique for Multidrop Memory InterfacesIEEE Transactions on Circuits and Systems II: Express Briefs, 2010
- Coupling circuitary for impedance adaptation in power line communications using VCGIC2008