On‐line prediction of final part dimensions in blow molding: A neural network computing approach
Authors:
- 1 June 1993
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 33 (11) , 653-664
Abstract
Control over final part thickness distributions in extrusion blow molding would be very useful in resin optimization. An on‐line measurement is essential for process monitoring and control of the part dimensions. Excessive resin usage results in material waste and increased cycle times because of increased cooling requirements. An inadequate thickness results in decreased mechanical strength, especially in regions along the part where large blow ratios or complex geometries exist. Neural networks are investigated as a method for the on‐line prediction of the final part distribution from the parison dimensions. The purpose of this work is to demonstrate the feasibility, for preliminary use, of neural networks for this application. The network inputs include the initial parison thickness and tempera‐ture profiles, the bottle mold geometry and a rheological parameter representative of the material. Varying blow‐up ratios are obtained from the bottle mold geome‐try. The network accesses data from a pool of eighty data sets for the training sequence. The data sets are broadly distributed with regard to the operating conditions, so as to give the network a wide range of applicability. The simulations are performed on data sets not present in the access pool used for training.Keywords
This publication has 17 references indexed in Scilit:
- Noncontact measurement of parison thickness profiles affected by swell and sag in continuous extrusion blow moldingPolymer Engineering & Science, 1992
- In-cycle Deterministic and Stochastic Dynamics of Extrusion Blow MoldingInternational Polymer Processing, 1992
- Inflation of an elastic cylindrical membrane: Non-linear deformation and instabilityInternational Journal of Solids and Structures, 1992
- Closed Loop Control of Parison Dimension Profiles in Extrusion Blow MoldingInternational Polymer Processing, 1991
- Parison swell—A new measurement method and the effect of molecular weight distribution for a high density polyethylenePolymer Engineering & Science, 1991
- Artificial neural network models of knowledge representation in chemical engineeringComputers & Chemical Engineering, 1988
- On-line measurement and estimation of parison dimensions in extrusion blow moldingAdvances in Polymer Technology, 1988
- An experimental investigation of capillary extrudate swell in relation to parison swell behavior in blow moldingPolymer Engineering & Science, 1986
- A model for parison behavior in the extrusion blow molding processAIChE Journal, 1985
- Theoretical and experimental study of non‐isothermal deformation of a blow molding parisonAdvances in Polymer Technology, 1983