Delineation of Optimized Single and Multichannel Approximate DA-Based Filter Design Using Influential Single MAC Strategy for Trans-Multiplexer
Open Access
Abstract
In this paper, a multichannel FIR filter design based on the Time Division Multiplex (TDM) approach that incorporates one multiply and add unit, regardless of the variable coefficient length and varying channels, by associating the resource sharing doctrine is suggested. A multiplier based on approximate distributed arithmetic (DA) circuits is employed for effective resource optimization. Although no explicit multiplication was conducted in this realization, the radix-8 and radix-4 Booth algorithms are utilized in the DA framework to curtail and optimize the partial products (PPs). Furthermore, the input stream is truncated with an erratum mending unit to roughly construct the partial products. For an aggregation of PPs, an approximate Wallace tree is taken into consideration to further minimize hardware expenses. Consequently, the suggested design’s latency, utilized area, and power usage are largely reduced. The Xilinx Vertex device is expedited, given the synthesis of the suggested multichannel realization with 16 taps, which is simulated using the Verilog formulary. It is observed that the filter structure with one channel produced the desired results, and the system’s frequency can support up to 429 MHz with a reduced area. Utilizing TSMC 180 nm CMOS technology and the Cadence RC compiler, cell-level performance is also achieved.Keywords
Funding Information
- Vel Tech Rangarajan Dr. Sagunthala R&D Institute of Science and Technology, Chennai, India (VTU SEED (FY 22-23)-16)
This publication has 24 references indexed in Scilit:
- A reconfigurable high-speed and low-complexity residue number system-based multiply-accumulate channel filter for software radio receiversWorld Journal of Engineering, 2022
- Approximate Radix-8 Booth Multipliers for Low-Power and High-Performance OperationIEEE Transactions on Computers, 2015
- High performance and low‐power finite impulse response filter based on ring topology with modified retiming serial multiplier on FPGAIET Signal Processing, 2013
- Joint use of DFT filter banks and modulated transmultiplexers for multicarrier communicationsSignal Processing, 2011
- New Reconfigurable Architectures for Implementing FIR Filters With Low ComplexityIEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems, 2010
- A Reconfigurable Mixed-Signal VLSI Implementation of Distributed Arithmetic Used for Finite-Impulse Response FilteringIEEE Transactions on Circuits and Systems I: Regular Papers, 2008
- LMS adaptive filters using distributed arithmetic for high throughputIEEE Transactions on Circuits and Systems I: Regular Papers, 2005
- Data-dependent truncation scheme for parallel multipliers2002
- Small side-lobe filter design for multitone data-communication applicationsIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1998
- Applications of distributed arithmetic to digital signal processing: a tutorial reviewIEEE ASSP Magazine, 1989