MoO3/SnO2Nanocomposite-Based Gas Sensor for Rapid Detection of Ammonia
- 28 October 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 70 (00189456) , 1-9
Abstract
Ammonia is harmful to human health, however, the detection limit of the sensor based on traditional semiconductor gas sensors is high and the speed is slow. Constructing heterostructure is an effective method to improve the performance of sensors. In this article, 1-D MoO 3 nanorods and SnO 2 nanoparticles are successfully combined to obtain MoO 3 /SnO 2 nanocomposite. The 1-D structure can increase the speed of electron transport, while the nanoparticles on the surface increase the specific surface area, more importantly, the structure maximizes the interface area between the two materials which can transfer electronic more efficiently. Scanning electron microscopy (SEM), transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM), selected area electron diffraction (SAED), energy dispersive spectrometer (EDS), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET), and Barrett–Joyner–Halenda (BJH) are used to analyze the microstructure and elemental composition of MoO 3 /SnO 2 . The diameter of MoO 3 /SnO 2 nanocomposite is approximately 200 nm and the distribution is uniform. The response of MoO 3 /SnO 2 nanocomposite to 100-ppm NH 3 is 12.7 at 280 °C, and the response/recovery time is 13/2 s. The detection limit for NH 3 can reach 10 ppb (response 1.3), which enables rapid detection of NH 3 at low concentration. Electron transport requires more energy to overcome the contact barrier between pure SnO 2 nanoparticles, which can also lead to electron emission and noise increase. However, the sensitive electrons of MoO 3 /SnO 2 nanocomposite can transmit electrons along the 1-D rod-like structure of MoO 3 , which undoubtedly accelerates the efficiency of electron transmission. Moreover, n-n heterojunction formed between MoO 3 and SnO 2 to bend the SnO 2 band and show better sensitivity to NH 3 . Therefore, MoO 3 /SnO 2 nanocomposite shows a low detection limit and a rapid response/recovery speed. Nevertheless, the nanoparticles on the surface of MoO 3 /SnO 2 nanocomposite begin to agglomerate with the increase of SnO 2 content, which leads to the decrease of gas-sensitive response. The formation process of MoO 3 /SnO 2 composites is also discussed in this article. The excellent gas sensing results show that MoO 3 /SnO 2 composites are a promising gas sensing material.Keywords
Funding Information
- National Key Research and Development Program of China (2020YFB2008700)
- National Natural Science Foundation of China (62033002, 61833006, 62071112, 61973058)
- Higher Education Discipline Innovation Project (B16009)
- Fundamental Research Funds for the Central Universities in China (N2004019, N2004028)
- Liaoning Revitalization Talents Program (XLYC1807198)
- Liaoning Province Natural Science Foundation (2020-KF-11-04)
- Hebei Natural Science Foundation (F2020501040)
This publication has 57 references indexed in Scilit:
- Selective sensing of NH 3 by Si-doped α-MoO 3 for breath analysisSensors and Actuators B: Chemical, 2016
- The n-ZnO/n-In2O3 heterojunction formed by a surface-modification and their potential barrier-control in methanal gas sensingSensors and Actuators B: Chemical, 2016
- Quasi-one-dimensional metal-oxide-based heterostructural gas-sensing materials: A reviewSensors and Actuators B: Chemical, 2015
- Combinatorial Investigation and Modelling of MoO3 Hole‐Selective Contact in TiO2|Co3O4|MoO3 All‐Oxide Solar CellsAdvanced Materials Interfaces, 2015
- Enhanced ethanol sensing performance of hollow ZnO–SnO2 core–shell nanofibersSensors and Actuators B: Chemical, 2015
- Nanoscale metal oxide-based heterojunctions for gas sensing: A reviewSensors and Actuators B: Chemical, 2014
- Gas sensors based on carbon nanoflake/tin oxide composites for ammonia detectionJournal of Hazardous Materials, 2014
- Synthesis of In2O3–ZnO core–shell nanowires and their application in gas sensingSensors and Actuators B: Chemical, 2011
- Fast response detection of H2S by CuO-doped SnO2 films prepared by electrodeposition and oxidization at low temperatureMaterials Chemistry and Physics, 2011
- Theory of power laws for semiconductor gas sensorsSensors and Actuators B: Chemical, 2008