Multi-Foci Laser Separation of Sapphire Wafers with Partial Thickness Scanning
Open Access
- 24 March 2022
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 13 (4) , 506
Abstract
With multi-foci laser cutting technology for sapphire wafer separation, the entire cross-section is generally scanned with single or multiple passes. This investigation proposes a new separation technique through partial thickness scanning. The energy effectivity and efficiency of the picosecond laser were enhanced through a two-zone partial thickness scanning by exploiting the internal reflection at the rough exit surface. Each zone spanned only one-third thickness of the cross-section, and only two out of three zones were scanned consecutively. A laser beam of 0.57 W and 50 kHz pulse repetition rate was split into 9 foci, each with a 2.20 μm calculated focused spot diameter. By only scanning the top two-thirds sample thickness, first its middle section then upper section, a cleavable sample could result. This was achieved with the lowest energy deposition at the fastest scanning speed of 10 mm/s investigated. Although with partial thickness scanning only, counter intuitively, the cleaved sample had a previously unattained uniform roughened sidewall profile over the entire thickness. This is a desirable outcome in LED manufacturing. As such, this proposed scheme could attain a cleavable sample with the desired uniformly roughened sidewall profile with less energy usage and faster scanning speed.Keywords
Funding Information
- Singapore Institute of Manufacturing Technology (U12-M- 007JL)
This publication has 23 references indexed in Scilit:
- A study on laser multi-focus separation technology of thick KDP crystalInternational Journal of Machine Tools and Manufacture, 2017
- GaN-based light-emitting diodes prepared with shifted laser stealth dicingJournal of Display Technology, 2015
- Investigation of light output performance for gallium nitride-based light-emitting diodes grown on different shapes of patterned sapphire substrateMaterials Science in Semiconductor Processing, 2015
- Performance enhancement by different sidewall structures for InGaN-based light-emitting diodesJournal of Materials Science: Materials in Electronics, 2014
- Multi-wire sawing of sapphire crystals with reciprocating motion of electroplated diamond wiresCIRP Annals, 2013
- Light extraction efficiency improvement by multiple laser stealth dicing in InGaN-based blue light-emitting diodesOptics Express, 2012
- Thermal stability of microstructural and optical modifications induced in sapphire by ultrafast laser filamentationJournal of Applied Physics, 2010
- Enhanced output power of near-ultraviolet InGaN-GaN LEDs grown on patterned sapphire substratesIEEE Photonics Technology Letters, 2005
- InGaN-Based Near-Ultraviolet and Blue-Light-Emitting Diodes with High External Quantum Efficiency Using a Patterned Sapphire Substrate and a Mesh ElectrodeJapanese Journal of Applied Physics, 2002
- Scribing and cutting a blue LED wafer using a Q-switched. Nd:YAG laserApplied Physics A, 2000