Ultrasonic testing of butt joints in electrotechnical steel plates using Lamb waves
Authors:
- 15 January 2023
- journal article
- research article
- Published by The Russian Academy of Sciences in Defektoskopiâ
- No. 1,p. 14-24
Abstract
Using Lamb waves, the influence of the welding quality of thin steel sheets on the physical and mechanical properties of electrical steel has been studied. It is shown that Lamb waves excited in the zero symmetric mode are an effective source of information about the state of the material both in the welded joint of plates and in the region of the base metal not affected by thermal effects. Markers of quality of welded joints are determined. It has been established that the most informative parameters are the phase velocity of the Lamb wave and its amplitude. On the basis of velocity measurements, a macroscopic anisotropy of the acoustic properties of the material was found. It is assumed that the origin of this anisotropy is due to residual stresses that arise in the technological process of processing steel sheets. The results obtained are of interest for specialized quality control of butt welds in thin steel sheets.Keywords
This publication has 28 references indexed in Scilit:
- Effect of Plastic Deformation and Subsequent Heat Treatment on the Acoustic and Magnetic Properties of 12Kh18N10T SteelInorganic Materials, 2020
- The dependence of local deformations and internal stress fields on welding technique for grade VSt3sp structural steel: I. The influence of welding technique on the mechanical characteristics and acoustic emission parameters of grade VSt3sp steelRussian Journal of Nondestructive Testing, 2015
- Ultrasonic estimation of the residual stressesInorganic Materials, 2014
- The ЛИСТ-4 mobile multichannel device for ultrasonic checking of sheetsRussian Journal of Nondestructive Testing, 2014
- Monitoring of Martensitic Transformation in Austenitic Stainless Steel 304 L by Eddy CurrentsResearch in Nondestructive Evaluation, 2010
- Identification of Damage Using Lamb Waves2009
- Eddy current detection of changes in stainless steel after cold reductionComputational Materials Science, 2008
- AISI 304 steel: anomalous evolution of martensitic phase following heat treatments at 400°CMaterials Science and Engineering: A, 2006
- Effects of Strain State and Strain Rate on Deformation-Induced Transformation in 304 Stainless Steel: Part I. Magnetic Measurements and Mechanical BehaviorMetallurgical Transactions A, 1982
- Tensile properties of metastable stainless steelsJournal of Materials Science, 1972