Influence of Preheating Temperature on the Microstructure and Mechanical Properties of 6061/TA1 Composite Plates Fabricated by AFSD
Open Access
- 1 September 2023
- Vol. 16 (17) , 6018
Abstract
In this study, composite plates of 6061/TA1 were successfully manufactured using additive friction stir deposition (AFSD). The impact of preheating temperatures (room temperature, 100 °C, 200 °C) on the interfacial microstructure and interface mechanical properties at various deposition zones was studied. The results showed that as the preheating temperature increased or when the deposit zone shifted from the boundary to the center, the diffusion width of Al and Ti increased, accompanied by an increase in bonding shear strength. Moreover, in the boundary zone of the sample preheated at room temperature (P-RT), only mechanical bonding was observed, resulting in the lowest bonding shear strength. Conversely, the other samples exhibited a combination of mechanical and metallurgical bonding. Under the preheating temperature of 200 °C, interfacial intermetallic compounds were observed near the center zone, which exhibited the highest bonding shear strength.Keywords
Funding Information
- Fundamental Research Funds for the Central Universities of Central South University (1053320220254, 202106370122)
- China Scholarship Council (1053320220254, 202106370122)
This publication has 51 references indexed in Scilit:
- Fabrication and Evaluation of Ti3Alp/Ti–6Al–4V Surface Layer via Additive Friction-Stir ProcessingMaterials and Manufacturing Processes, 2014
- Fabrication of nanostructured Al/Cu/Mn metallic multilayer composites by accumulative roll bonding process and investigation of their mechanical propertiesMaterials & Design (1980-2015), 2014
- Effects of welding speed on the microstructure and hardness in friction stir welding joints of 6005A-T6 aluminum alloyMaterials & Design (1980-2015), 2013
- Numerical modeling of friction stir welding process: a literature reviewThe International Journal of Advanced Manufacturing Technology, 2012
- Effect of material locations on properties of friction stir welding joints of dissimilar aluminium alloysScience and Technology of Welding and Joining, 2010
- Formation process of the bonding joint in Ti/Al diffusion bondingMaterials Science and Engineering: A, 2008
- Hierarchies in Biomineral StructuresScience, 2005
- An analytical model for the heat generation in friction stir weldingModelling and Simulation in Materials Science and Engineering, 2003
- Effect of metal surface topography on mechanical bonding at simulated total hip stem-cement interfacesJournal of Biomedical Materials Research, 1999
- The precipitation sequence in Al–Mg–Si alloysActa Materialia, 1998