Calculating the Load Distribution and Contact Stress of the Disposable Harmonic Drive under Full Load
Open Access
Abstract
Mechanical equipment that will not be reused is defined as disposable machinery. Disposable harmonic drives (HDs) are commonly used in the field of aerospace and are sensitive to payloads. Reasonable calculation of the gear strength is essential for structural design. A method of calculating the contact characteristics of HDs under full load by combining a surface contact model with a three-dimensional finite element model (FEM) is proposed in this work. The mathematical model was established for calculating the no-load backlash of conventional and disposable harmonic gears after assembly. Afterward, the tooth load distribution and surface contact stress were determined using the Hertz contact theory. Finally, ABAQUS software was used to establish the FEM of the disposable HD, and the results were compared with those obtained from the theoretical model. The results revealed that the disposable harmonic gear can realize short-term transmission under full load.Keywords
Funding Information
- National Natural Science Foundation of China (51875117)
- Fundamental Research Funds for the Central Universities (LH2020E035)
This publication has 30 references indexed in Scilit:
- A novel method based on mechanical analysis for the stretch of the neutral line of the flexspline cup of a harmonic driveMechanism and Machine Theory, 2014
- Dynamic Simulation of Harmonic Gear Drives Considering Tooth Profiles Parameters OptimizationJournal of Computers, 2012
- Shape optimization of tooth profile of a flexspline for a harmonic drive by finite element modellingMaterials & Design (1980-2015), 2007
- Gear Contact Model and Loaded Tooth Contact Analysis of a Three-Dimensional, Thin-Rimmed GearJournal of Mechanical Design, 2002
- Deformation and Bending Stress Analysis of a Three-dimensional, Thin-rimmed GearJournal of Mechanical Design, 2001
- Modeling and Parameter Identification of Harmonic Drive SystemsJournal of Dynamic Systems, Measurement, and Control, 1998
- Effect of Contact Ratio on Spur Gear Dynamic Load With No Tooth Profile ModificationsJournal of Mechanical Design, 1996
- Computer-Aided Design of High-Contact-Ratio Gears for Minimum Dynamic Load and StressJournal of Mechanical Design, 1993
- Investigation of the stress-strain state of flexible elements in wave drivesInternational Applied Mechanics, 1981
- Calculating the stress and strain state of the flexible wheel of a wave toothed transmissionInternational Applied Mechanics, 1973