Abstract
The analysis of the dependence of the density and viscosity of the water-oil emulsion not only on the temperature, the quantitative content of the water phase in it, but also on the technical means and technological parameters of its preparation was carried out. The purpose of the work is to study the changes in the rheological parameters of water-oil emulsions depending on the equipment used and the technological parameters of their preparation. A high degree of dispersion is ensured by hydrodynamic factors and the mechanical effect on the particles of a heterogeneous environment, which consists in impact, shearing and abrasive loads in direct contact of the dispersions with the working elements of the rotor-pulsation device. As the basic model of the rotor-pulsation device, the design of the cylindrical-type apparatus is used, consisting of three coaxially placed cylindrical elements: two stators and a rotor rotating between them. The dependences of the change in the density and viscosity of water-oil emulsion on processing in the rotor-pulsation device at different frequencies of flow pulsations and the number of processing cycles were established. It has been proven that the viscosity of water-oil emulsion depends on the size of the average diameter of the droplets of the dispersed phase (water), which varies depending on the processing parameters. An increase in the number of processing cycles from 1 to 5 at a frequency of flow pulsations from 1 to 4 kHz, depending on the amount of water phase, can increase the viscosity by 1,1–1,8 times. When designing and operating fuel plants, taking into account the preparation of water-oil emulsion in them using rotor-pulsation device, it is necessary to take into account the nature of the change in viscosity depending on the content of the aqueous phase, the number of processing cycles, the frequency of flow pulsations, and the average diameter of particles of the dispersed phase (water). Taking into account the nature of the change in viscosity, it is necessary to make appropriate adjustments to the selection of technological equipment and pipelines, as well as to the technological modes of preparing water-oil emulsion for incineration, or, on the contrary, adjust the viscosity value in relation to the existing equipment. Bibl. 17, Fig. 2, Tab. 4.

This publication has 9 references indexed in Scilit: