Elucidating the effects of metal transfer modes and investigating the material properties in wire-arc additive manufacturing (WAAM)
Open Access
- 25 September 2024
- journal article
- research article
- Published by Springer Nature in Progress in Additive Manufacturing
- Vol. 10 (5) , 3335-3360
Abstract
Studies have shown the influence of WAAM process parameters on mechanical properties, bead formation, dimensional accuracy, and microstructure. However, metal transfer modes and their interactions with input variables have not been investigated thoroughly. Therefore, short/spray, pulse and double pulse modes were investigated in this study at different current levels. Bead-on-plate trials were conducted by depositing ER70S-6 wire to investigate bead morphology, dilution, microstructure, and hardness. The study was supported by a detailed statistical approach, including analysis of variance (ANOVA) and regression analysis. Similarly, the combined effects of hatch distance and current were studied on bead formation in multi-layer deposits. Moreover, a thin wall and a cubic structure were deposited to realize the WAAM capability for larger depositions. The microstructures of thin wall and cubic structure were analyzed using optical microscopy (OM) and scanning electron microscopy (SEM). The study concludes that metal transfer modes at various currents significantly influence bead geometry, microstructure and hardness. The microstructure of bead-on-plate trials show fine lamellar structure at low current in all modes. Higher current results in coarse grains with a polygonal and columnar morphology. The hardness shows a decreasing trend as the current increases. The combined effects of current and hatch distance alter bead morphology; however, an optimized combination yields smoother surfaces. The microstructure of thin wall showed a slight anisotropy along the building direction. The presence of small pores was witnessed from OM and SEM images. Similarly, the cubic structure showed a more homogeneous microstructure with much lower porosity. The hardness profile of the thin wall exhibited small fluctuations along the building direction, while that of the cubic structure was more uniform.Keywords
Funding Information
- Alma Mater Studiorum - Università di Bologna
This publication has 68 references indexed in Scilit:
- Applications of wire arc additive manufacturing (WAAM) for aerospace component manufacturingThe International Journal of Advanced Manufacturing Technology, 2023
- Comparison of the Microstructures and Mechanical Properties in the Overlapping Region of Low Carbon Steel Additive Bead Fabricated by WAAM and FSPMetallurgical and Materials Transactions A, 2023
- Effect of interlayer delay on microstructure and bead geometry of wire arc additive manufactured low carbon steel componentsInternational Journal on Interactive Design and Manufacturing (IJIDeM), 2022
- On Microstructure and Mechanical Properties of a Low-Carbon Low-Alloy Steel Block Fabricated by Wire Arc Additive ManufacturingJournal of Materials Engineering and Performance, 2021
- Grain Refinement of Alloys in Fusion-Based Additive Manufacturing ProcessesMetallurgical and Materials Transactions A, 2020
- Wire arc additive manufacturing of high-strength low alloy steels: study of process parameters and their influence on the bead geometry and mechanical characteristicsThe International Journal of Advanced Manufacturing Technology, 2020
- Microstructural evolution and mechanical properties of a low-carbon low-alloy steel produced by wire arc additive manufacturingThe International Journal of Advanced Manufacturing Technology, 2019
- Heat treatment effects on Inconel 625 components fabricated by wire + arc additive manufacturing (WAAM)—part 1: microstructural characterizationThe International Journal of Advanced Manufacturing Technology, 2019
- Additive manufacturing using plasma transferred arcThe International Journal of Advanced Manufacturing Technology, 2015
- Effect of Powder Reuse Times on Additive Manufacturing of Ti-6Al-4V by Selective Electron Beam MeltingJOM, 2015