Green Composites Based on PLA and Cotton Fabric Waste: Preparation and Characterization
Open Access
Abstract
Textile waste, from both consumption and production, has dramatically increased due to a lack of diversification in its use. Increasing the number of textile alternatives can help to solve these problems. Producing a green composite product is an interesting alternative method. The objectives of this work were to study the preparation and characterization of green composites created from PLA and cotton fabric waste (CFW) and to consider the effect of the CFW content on the composites. The procedure of the research began with CFW pellets preparation; this was subsequently compounded with PLA pellets using a melt-mixing technique with a twin-screw extruder at ratios of 90:10, 80:20, and 70:30 wt% between the PLA and cotton fabric waste, respectively. Then, the testing specimens were produced by compression molding. The experiments demonstrated that an increase in the CFW caused an increase in the viscosity, stiffness, Tg, Tm, and water absorption of the composites. The decomposition temperature of the composites showed a range of 302.41 to 361.22 °C; this decreased when the CFW increased. An increase in the CFW also produced greater and clearer phase separation and roughness on the fracture surface area.Keywords
Funding Information
- Srinakharinwirot University (550/2564)
This publication has 32 references indexed in Scilit:
- Green composites: An overviewPolymer Composites, 2011
- Characteristics of poly(lactic acid) reinforced composites with waste cottonJournal of Polymer Engineering, 2011
- Biodegradable poly(L‐lactic acid)/TiO2 nanocomposites: Thermal properties and degradationJournal of Applied Polymer Science, 2011
- Green composites: A brief reviewComposites Part A: Applied Science and Manufacturing, 2011
- Preparation, characterization, and properties of TiO 2 /PLA nanocomposites by in situ polymerizationPolymer Composites, 2008
- Chopped glass and recycled newspaper as reinforcement fibers in injection molded poly(lactic acid) (PLA) composites: A comparative studyComposites Science and Technology, 2006
- The effect of alkalization and fibre alignment on the mechanical and thermal properties of kenaf and hemp bast fibre composites: Part 1 – polyester resin matrixComposites Science and Technology, 2004
- Effect of compatibilization on the performance of biodegradable composites using cotton fiber waste as fillerJournal of Applied Polymer Science, 2003
- Chemical modification of hemp, sisal, jute, and kapok fibers by alkalizationJournal of Applied Polymer Science, 2002
- Polyethylene‐structure, crystallinity and propertiesJournal of Chemical Technology & Biotechnology, 1951