Influence of NiO to SDC ratio on the properties of Ni-SDC cermet prepared via reduction process
Open Access
- 1 December 2019
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 701 (1) , 012028
Abstract
This works presents the preparation of Ni-Ce0.8Sm0.2O1.9 (Ni-SDC) ceramic-metal from reduction of NiO-Ce0.8Sm0.2O1.9 (NiO-SDC) ceramics for application of solid oxide fuel cell. NiO-SDC powder with different weight percentage of NiO and SDC (100% NiO + 0% SDC), (80% NiO + 20% SDC), (70% NiO + 30% SDC) and (60% NiO + 40% SDC) was pelletized and sintered at 1400 °C for 4 hours. Then, pellet samples were undergone reduction process using mixed gas of hydrogen and nitrogen gas with concentration of 40% H2 and 60% N2 at 800 °C for 2 h. Phase analysis was done using X-ray Diffraction and it was found that for all samples, NiO was completely reduced to Ni, meanwhile SDC was remained in its phase. The density of the samples decreased after reduction, results in more porous samples were obtained. It was found that increasing NiO content lead to sample with higher porosity. The surface morphology of the samples was observed by using the Scanning Electron Microscopy.Keywords
This publication has 14 references indexed in Scilit:
- A review on the selection of anode materials for solid-oxide fuel cellsRenewable and Sustainable Energy Reviews, 2015
- Metallizing porous scaffolds as an alternative fabrication method for solid oxide fuel cell anodesJournal of Power Sources, 2015
- Effect of casting slurry composition on anode support microstructure and cell performance of MT-SOFCs by phase inversion methodElectrochimica Acta, 2014
- Reduction of Nickel Oxide Powder and Pellet by HydrogenTransactions of the Indian Institute of Metals, 2012
- Materials for Solid Oxide Fuel CellsChemistry of Materials, 2009
- Synthesis of nickel nanoparticles supported on hollow samaria-doped ceria particles via the solution-spray plasma technique: Anode catalysts for SOFCsSolid State Ionics, 2009
- The influence of pore and Ni morphology on the electrical conductivity of porous Ni/YSZ composite anodes for use in solid oxide fuel cell applicationsSolid State Ionics, 2009
- A novel technique of three-dimensional reconstruction segmentation and analysis for sliced images of biological tissuesJournal of Zhejiang University-SCIENCE B, 2005
- Effects of the Use of Pore Formers on Performance of an Anode Supported Solid Oxide Fuel CellJournal of the American Ceramic Society, 2005
- Kinetics of the reduction of nickel oxide by hydrogenChemical Engineering Science, 1962