Mechanical Properties of the Ti49.8Ni50.2 Alloy after Multi-Axial Forging at 573 K
Authors:
Open Access
Abstract
The mechanical properties of Ti49.8Ni50.2 (at %) alloy under tension at room temperature are studied in dependence on the true strain (e = 1.84–9.55) specified during isothermal multi-axial forging (abc-pressing). It was found that the stress at the beginning of the pseudoyield plateau does not depend on the value of the true abc-strain. It was found that after abs-pressing, already at a true strain e = 1.84, the yield stress σy was 900 ± 25 MPa, which is more than twice as high as compared to σy in the initial state of the specimens. With a further increase in the abc-strain, the yield stress continues to increase slightly and reaches 1000 ± 25 MPa at e = 9.55. In this case, the ultimate tensile strength of the samples increases by about 15%. The strain-hardening coefficient ϴ = dσ/dε at the III (linear) stage of the σ(ε) curve has a similar dependence on e. It is shown that after abc-pressing with e from 1.84 to 9.55, the yield stress and ultimate tensile increase linearly with increasing d−1/2 in accordance with the Hall–Petch relation, where d is the average grain–subgrain size.Keywords
Funding Information
- Government research assignment for ISPMS SB RAS (FWRW-2021-0004)
This publication has 20 references indexed in Scilit:
- Extreme grain refinement by severe plastic deformation: A wealth of challenging scienceActa Materialia, 2013
- Ultrafine structure and martensitic transformation in titanium nickelide after warm abc pressingInorganic Materials: Applied Research, 2011
- Thermomechanical cyclic response of an ultrafine-grained NiTi shape memory alloyActa Materialia, 2008
- Structure and properties of Ti–Ni-based alloys after equal-channel angular pressing and high-pressure torsionMaterials Science and Engineering: A, 2008
- Mechanical properties of nanocrystalline materialsProgress in Materials Science, 2006
- Evolution of misorientation distribution during warm ‘abc’ forging of commercial-purity titaniumMaterials Science and Engineering: A, 2006
- Estimating grain-size distributions in nanocrystalline materials from X-ray diffraction profile analysisPhilosophical Magazine A, 1998
- Stacking faults in face-centred cubic metals and alloysPhilosophical Magazine, 1957
- III. Dislocation densities in some annealed and cold-worked metals from measurements on the X-ray debye-scherrer spectrumPhilosophical Magazine, 1956
- The Separation of Cold-Work Distortion and Particle Size Broadening in X-Ray PatternsJournal of Applied Physics, 1952