Evaluation of the marginal fit of finish line designs of novel CAD/CAM restoration materials
Open Access
- 12 January 2023
- journal article
- research article
- Published by Journal of Health Sciences and Medicine in Journal of Health Sciences and Medicine
- Vol. 6 (1) , 116-121
Abstract
Aim: The purpose of this study is to compare the marginal fit of crowns manufactured using different CAD/CAM materials on 2 different types of finish line design.Material and Method: Tooth preparations were made by creating 2 different finish lines (rounded shoulder, chamfer) on an acrylic mandibular second premolar model. Impressions were taken on each preparation using polyvinylsiloxane impression material, and blocks with three different compositions including lithium disilicate (LDS), zirconia-reinforced lithium silicate (ZLS), and monolithic zirconia (MZ) (UP.CAD, Celtra Duo, and VITA YZ HT) were produced using a CAD/CAM (computer-aided-design and computer-aided-manufacturing) milling device (VHF R5) (n=10). The marginal gap values of the crown restorations were measured by the same operator using a stereomicroscope (LEICA DVM6). Histogram plots and the Kolmogorov-Smirnov test were used to test the normality of the distributions of the variables. The non-normally distributed (nonparametric) variables were compared using the Mann-Whitney U test for two groups and the Kruskal-Wallis test for more than two groups.Results: The marginal gap values were compared between finish line designs separately for each material. Accordingly, the marginal gap values of the rounded shoulder finish line were smaller than those of the chamfer finish line in all materials. The marginal gap values were also compared among the materials separately for each finish line type. Accordingly, the marginal gap values of the VITA YZ HT (MZ) material were smaller than those of the Celtra Duo (ZLS) and UP.CAD (LDS) materials for both finish line designs. There was no significant difference between Celtra Duo and UP.CAD.Conclusion: The finish line design is a factor that affects marginal fit. Monolithic zirconia is more appropriate for clinical use as it shows a better marginal fit compared to LDS and ZLS.Keywords
This publication has 37 references indexed in Scilit:
- Marginal adaptation of zirconium dioxide copings: Influence of the CAD/CAM system and the finish line designThe Journal of Prosthetic Dentistry, 2014
- Accuracy of ceramic restorations made with two CAD/CAM systemsThe Journal of Prosthetic Dentistry, 2013
- Influence of Cervical Finish Line Type on the Marginal Adaptation of Zirconia Ceramic CrownsOperative Dentistry, 2009
- Evaluation of the marginal fit of three margin designs of resin composite crowns using CAD/CAMJournal of Dentistry, 2007
- Vertical marginal discrepancy of ceramic copings with different ceramic materials, finish lines, and luting agents: an in vitro evaluationThe Journal of Prosthetic Dentistry, 2004
- Tooth preparations for complete crowns: An art form based on scientific principlesThe Journal of Prosthetic Dentistry, 2001
- Marginal fit consistency of copy-milled all-ceramic crowns during fabrication by light and scanning electron microscopic analysis in vitroJournal of Oral Rehabilitation, 1997
- An investigation of dental luting cement solubility as a function of the marginal gapThe Journal of Prosthetic Dentistry, 1991
- Considerations in measurement of marginal fitThe Journal of Prosthetic Dentistry, 1989
- The estimation of cement film thickness by an in vivo techniqueBritish Dental Journal, 1971