Suspended Insulation Structure Design for Infrared Thermal Detector
- 9 December 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 34 (1) , 92-99
Abstract
Infrared thermal detectors generate signal output utilizing thermal effect, with detection performance being dictated by the structure design of the detector. To ensure effective thermal insulation, detectors are typically designed with slender supporting beams to reduce thermal conductivity and enhance signal output. In this paper, a fluorescent infrared detector with different isolation beam designs is proposed to investigate the trade-off relationship among detector performance parameters. Two kinds of isolation beams are theoretically derived to minimize the thermal conductivity for specific detection unit, and the thermal detectors with suspending units are manufactured by MEMS technology. The thermal imaging results for a 623 K heat source indicate that the temperature rise for the two-beam structure (i.e. 46.7 K) exceeds that of the four-beam structure (i.e. 38.3 K). Additionally, the detectivity of 4.05 $\times$ 10 $^{\mathbf{7}}$ cm $\cdot$ Hz $^{\mathbf{1/2}}$ /W is obtained by the two-beam structure, which is lower than that of the four-beam structure (i.e. 5.80 $\times$ 10 $^{\mathbf{7}}$ cm $\cdot$ Hz $^{\mathbf{1/2}}$ /W). The temporal resolution and NETD are also calculated and compared. The findings demonstrate that in designing thermal detectors, deliberately sacrificing a portion of the detectivity within an acceptable range and reducing beam thermal conductivity can significantly enhance temperature rise and increase signal output. 2024-0131Keywords
Funding Information
- infrared detector chip and system integration
- Shenzhen Science and Technology Program (GJHZ20210705141806019)
- Natural Science Foundation of Guangdong Province (2022A1515011935)
This publication has 26 references indexed in Scilit:
- Scaling infrared detectors—status and outlookReports on Progress in Physics, 2022
- MEMS based bimorph optical temperature sensorJournal of Applied Physics, 2022
- Determination of thermal conductivity, thermal diffusivity and specific heat capacity of porous silicon thin films using the 3ω methodInternational Journal of Heat and Mass Transfer, 2022
- Monolayer MoS2/GaAs heterostructure self-driven photodetector with extremely high detectivityNano Energy, 2016
- Thermal crosstalk simulation and measurement of linear terahertz detector arraysInfrared Physics & Technology, 2015
- Uncooled infrared thermal imaging sensor using vacuum-evaporated europium phosphorJournal of Micromechanics and Microengineering, 2015
- Monolithic pyroelectric infrared detectors using SiO2 aerogel thin filmsSensors and Actuators A: Physical, 2015
- Infrared thermal detector array using Eu(TTA)3-based temperature sensitive paint for optical readable thermal imaging deviceJournal of Micromechanics and Microengineering, 2015
- Electrosprayed poly(vinylidene fluoride) microparticles for tissue engineering applicationsRSC Advances, 2014
- Fabrication and characterization of SRN/SU-8 bimorph cantilevers for temperature sensingMicroelectronic Engineering, 2011