LTCC With Temperature Sensor Array for Monitoring of Reactive Die Bond Processes–Design Optimization Using CFD
- 5 January 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 14 (1) , 122-129
Abstract
This paper discusses a design optimisation for the integration of a temperature sensor array for monitoring the spatially distributed course of process temperature during a reactive die-bond process. Since reactive multilayer systems produce the entire fusion heat in a millisecond time frame, it is very difficult to get information about the dynamics of a joining process that they are employed for. Most of the monitoring methods for reactive multilayers are based on high-speed cameras, which cannot be employed in case of a die-bond process. Therefore, this paper studies the influence on temperature measurements in a LTCC (Low Temperature Cofired Ceramics) substrate for different propagation speeds of reactive foils used during bonding processes by CFD (Computational Fluid Dynamics) simulation methods. The assumed reactive multilayer foil thickness is 40 μm. Different speeds of 1, 10 and 100 m/s were studied and temperature probes in the substrate were analysed to try and ascertain the potential limitations of temperature measurements made through probes embedded in an LTCC substrate. It was found that the temperature probes would tend to underestimate the reaction speed, particularly at increased depth, but this can be recovered relatively successfully with judicious selection of criteria for experimentally determining the reaction speed. The results of the simulation study give valuable information for the LTCC layout process with regard to the lateral and the z-axes position of multiple temperature probes forming a 3-dimensional sensor array in the multilayer LTCC substrate. Moreover, the simulation can provide a calibration factor to estimate the real course of process temperature during a reactive die bond process from the lagged temperature responses of the temperature probes inside the LTCC substrate.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (426204742)
This publication has 17 references indexed in Scilit:
- The Simulated Effect of Adding Solder Layers on Reactive Multilayer Films Used for Joining ProcessesApplied Sciences, 2022
- CFD Simulations of Reactive Multi-Layer Usage in Joining Processes2020
- Power Electronic Assemblies on Printed Wiring Boards Mounted by Silver Sintering2018
- Ni 3 Sn 4 -composed die bonded interface rapidly formed by ultrasonic-assisted soldering of Sn/Ni solder paste for high-temperature power device packagingMaterials & Design, 2016
- Die-attachment technologies for high-temperature applications of Si and SiC-based power devices2015
- Fabrication of Nanoparticle‐Containing Films and Nano Layers for Alloying and JoiningAdvanced Engineering Materials, 2014
- High Temperature Interconnect and Die Attach Technology: Au–Sn SLID BondingIEEE Transactions on Components, Packaging and Manufacturing Technology, 2013
- Transient liquid phase sintered attach for power electronics2013
- Reactive Bonding and Low Temperature Bonding of Heterogeneous MaterialsECS Transactions, 2010
- Room temperature soldering of microelectronic components for enhanced thermal performance2005