AC Losses in the First ITER CS Module Tests: Experimental Results and Comparison to Analytical Models
- 24 February 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Applied Superconductivity
- Vol. 31 (5) , 1-5
Abstract
The ITER Central Solenoid (CS) will be manufactured by assembling a stack of six modules, which are under fabrication by the US ITER organization and its subcontractors. The tests of the first CS Module have been performed at the premises of the General Atomics (GA) facility in Poway (US), in order to check compliance to the ITER requirements. Among other tests, the magnet was submitted to exponential dumps of the transport current from different initial values (10, 15, 20, 22.5, 25, 35, 40 kA) down to 0 kA. These tests are aimed at conducting DC breaker commissioning of the test facility and were used to measure the AC losses in the coil during electrodynamic transients. This paper presents the results of these measurements, along with a comparison with analytical computations of the losses in the magnet.Keywords
Funding Information
- Università di Bologna (#/IO/17/CT/4300001613)
- UT-Battelle (4000148178)
- Euratom research and training program (2014-2018, 2019-2020, 633053)
This publication has 13 references indexed in Scilit:
- Analysis of AC Losses in a CS Conductor Sample for the ITER ProjectIEEE Transactions on Applied Superconductivity, 2017
- Characterization of the ITER CS conductor and projection to the ITER CS performanceFusion Engineering and Design, 2017
- AC Coupling Losses in CICCs: Analytical Modeling at Different StagesIEEE Transactions on Applied Superconductivity, 2016
- Analysis of AC Losses in the ITER Central Solenoid Insert CoilIEEE Transactions on Applied Superconductivity, 2016
- ITER Central Solenoid Insert Test ResultsIEEE Transactions on Applied Superconductivity, 2016
- Full-scale calculation of the coupling losses in ITER size cable-in-conduit conductorsSuperconductor Science and Technology, 2011
- A macroscopic model for coupling current losses in cables made of multistages of superconducting strands and its experimental validationCryogenics, 2010
- An Optimized Central Solenoid for ITERIEEE Transactions on Applied Superconductivity, 2010
- Methods, Accuracy and Reliability of ITER Conductor Tests in SULTANIEEE Transactions on Applied Superconductivity, 2009
- The ITER Magnet SystemIEEE Transactions on Applied Superconductivity, 2008