Secondary Flows, Endwall Effects, and Stall Detection in Axial Compressor Design
- 1 May 2015
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 137 (5) , 051004
Abstract
This paper describes a methodology and a fully tested and calibrated mathematical model for the treatment of endwall effects in axial compressor aerodynamic calculations. Additional losses and deviations caused by the clearance and secondary flows are analyzed. These effects are coupled with endwall boundary layer losses (EWBL) and blockage development. Stall/surge detection is included, and mutual interaction of different loss mechanisms is considered. Individual mathematical correlations for different effects have been created or adopted from earlier papers with the aim of forming one integral model that is completely described in this paper. Separate mathematical correlations and calibration measures are discussed in detail in the first part of the paper. The developed overall model is suitable for application in two-dimensional (2D) or mean-line compressor flow calculations. During the development, it was tested, calibrated, and validated using throughflow calculations comparing numerical results with experimental data for a large number of test cases. These test cases include compressors with very different configurations and operating ranges. The data on the compressors were taken from the open literature or obtained from industrial partners.Keywords
This publication has 10 references indexed in Scilit:
- Experiments and Computations on Large Tip Clearance Effects in a Linear CascadeJournal of Turbomachinery, 2010
- Improved Blade Profile Loss and Deviation Angle Models for Advanced Transonic Compressor Bladings: Part I—A Model for Subsonic FlowJournal of Turbomachinery, 1996
- The 1993 IGTI Scholar Lecture: Loss Mechanisms in TurbomachinesJournal of Turbomachinery, 1993
- Modeling the 3-D Flow Effects on Deviation Angle for Axial Compressor Middle StagesJournal of Engineering for Gas Turbines and Power, 1986
- Stalling Pressure Rise Capability of Axial Flow Compressor StagesJournal of Engineering for Power, 1981
- End-Wall Boundary Layers in Axial CompressorsJournal of Engineering for Power, 1974
- Methods of Predicting the Tip Clearance Effects in Axial Flow TurbomachineryJournal of Basic Engineering, 1970
- The Off-Design Analysis of Axial-Flow CompressorsJournal of Engineering for Power, 1967
- A Practical Method of Predicting Transonic-Compressor PerformanceJournal of Engineering for Power, 1961
- Loss and Stall Analysis of Compressor CascadesJournal of Basic Engineering, 1959