Reduction of Hole Injection Barrier Height at TCO/P Interface Using a-SiO:H Interlayer
- 22 November 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 8 (1) , 8-15
Abstract
In a thin film, p-i-n solar cell the front contact interface loss due to high band bending between TCO front contact and p-type window layer can be minimized by inserting a wind band gap hydrogenated amorphous silicon oxide interlayer at the TCO/p interface. In this paper, a simulation and experimental investigation on the performance of p-i-n solar cell by inserting the intrinsic hydrogenated amorphous silicon oxide (i-a-SiO:H) at the TCO/p interface has been carried out. A device quality wide bandgap i-a-SiO:H interlayer was prepared at 230 °C substrate temperature by using radio frequency plasma-enhanced chemical vapor deposition (13.56 MHz RF-PECVD) technique. The experimental results in this study showed that the integration of interlayer at the TCO/p interface reduces the barrier height from 0.513 to 0.472 eV resulting the power conversion efficiency (η) of 9.38% and fill factor (FF) of 74.8% for a single-junction p-i-n solar cell with an active area of 1.0 cm2. In addition, the electrically and optically calibrated simulations also confirm that the application of interlayer at the TCO/p interface reduces the barrier height. As a result, the electric filed over the frontal region has decreased, which aided to minimize the recombination of photogenerated holes with back diffusing electrons at the front contact. The spectral response of the solar cell with interlayer has also improved significantly in the lower wavelength region (350–600 nm) in comparison to the cell without an interlayer at the TCO/p interface.Keywords
This publication has 36 references indexed in Scilit:
- Design of Schottky Contacts for Optimum Performance of Thin-Film Silicon Solar CellsIEEE Journal of Photovoltaics, 2014
- The role of buffer layer between TCO and p-layer in improving series resistance and carrier recombination of a-Si:H solar cellsMaterials Research Bulletin, 2012
- Interface modification effect between p-type a-SiC:H and ZnO:Al in p-i-n amorphous silicon solar cellsDiscover Nano, 2012
- Characterization and simulation of a-Si:H/μc-Si:H tandem solar cellsSolar Energy Materials and Solar Cells, 2011
- Optical modeling of a-Si:H solar cells with rough interfaces: Effect of back contact and interface roughnessJournal of Applied Physics, 2000
- Wide optical-gap a-SiO:H films prepared by rf glow dischargeJournal of Non-Crystalline Solids, 1997
- A computer analysis of the effect of a wide-band-gap emitter layer on the performance of a-Si:H-based heterojunction solar cellsJournal of Applied Physics, 1996
- Effect of contact barrier heights on a-Si:H p-i-n detector and solar-cell performanceJournal of Applied Physics, 1992
- Computer analysis of the role of p-layer quality, thickness, transport mechanisms, and contact barrier height in the performance of hydrogenated amorphous silicon p-i-n solar cellsJournal of Applied Physics, 1991
- Barrier at the interface between amorphous silicon and transparent conducting oxides and its influence on solar cell performanceJournal of Applied Physics, 1983