A Robust Exciter Controller Design for Synchronous Condensers in Weak Grids
- 8 September 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Systems
- Vol. 37 (3) , 1857-1867
Abstract
Weak grid scenarios and low-inertia systems are emerging issues in power systems, which could lead to voltage and frequency instabilities. Synchronous Condensers (SynCons) have recently drawn renewed attention as a promising solution to provide system strength and inertia support. Even though the exciter control of SynCons is a well-established technology, further developments are required to guarantee the stability of post-fault operations, in particular, in weak grids. This paper proposes a data-driven approach for designing higher-order optimized exciter controllers to meet this requirement. A pseudo-random binary sequence (PRBS)-based system identification method is used to obtain frequency response data of the power system, from the exciter point of view, which is then fed into the proposed optimal control design procedure. The proposed exciter controller is tested for voltage ride-through and fault scenarios in a single machine infinite bus (SMIB) case and the IEEE 39-bus test system to assess its performance compared to the conventional AC1A exciter controller. The results obtained through simulation tests carried out using the PSCAD/EMTDC software verify that the proposed exciter controller guarantees the post-fault stability in both strong and weak grids.Keywords
Funding Information
- Australian Renewable Energy Agency (2020/ARP007)
This publication has 33 references indexed in Scilit:
- A data-driven approach to robust control of multivariable systems by convex optimizationAutomatica, 2017
- Minimum Synchronous Inertia Requirement of Renewable Power SystemsIEEE Transactions on Power Systems, 2017
- Efficient PID controller tuning method selection to be used in excitation system of brushless synchronous generator2016
- Decoupled $dq$-Current Control of Grid-Tied Voltage Source Converters Using Nonparametric ModelsIEEE Transactions on Industrial Electronics, 2012
- IEEE Guide for Planning DC Links Terminating at AC Locations Having Low Short-Circuit Capacities2008
- IEEE Recommended Practice for Industrial and Commercial Power System Analysis2008
- Initial Results in Power System Identification From Injected Probing Signals Using a Subspace MethodIEEE Transactions on Power Systems, 2006
- System Identification of Power Converters With Digital Control Through Cross-Correlation MethodsIEEE Transactions on Power Electronics, 2005
- YALMIP : a toolbox for modeling and optimization in MATLAB2005
- Changes to IEEE 421.5 recommended practice for excitation system models for power system stability studies2005