Adhesion between ethylene‐propylene‐diene monomer and thermoplastics in two‐component injection molding: Effect of dicumylperoxide as curing agent
- 23 March 2020
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 137 (41)
Abstract
Strong adhesion at the interface is an important aspect in two‐component (2K) injection molding. It was therefore investigated whether dicumylperoxide (DCP) as curing agent in ethylene‐propylene‐diene monomer (EPDM) could stimulate interdiffusion and/or induce chemical bonding with thermoplastics. EPDM mixtures containing DCP concentrations between 2 to 8 parts per hundred rubber (phr) were combined with polar and non‐polar thermoplastics. Changes in EPDM physico‐mechanical bulk properties were analyzed, and the adhesion was evaluated by high temperature contact angle measurements and tensile testing. Results showed that DCP concentration did not influence EPDM‐thermoplastic compatibility. However, EPDM adhesion with polyethylene (PE) did improve when using up to 6 phr DCP (57% adhesion) as crosslinking is promoted. While with polypropylene (PP), adhesion linearly decreased (from 55% to 35% adhesion) with higher DCP concentrations due to prevailing scission reactions. Adhesion through chemical bonding with acrylonitrile‐butadiene‐styrene (ABS) caused better adhesion at 4 phr (43% adhesion) compared to polycarbonate (PC) at 4 phr (13% adhesion) where only limited interdiffusion occurs. Thus, selecting the optimal DCP concentration is highly important to boost adhesion between EPDM and thermoplastics. Furthermore, at these optimal DCP concentrations, physico‐mechanical properties require consideration as these properties were significantly affected.Keywords
Funding Information
- Fonds Wetenschappelijk Onderzoek (1SB0319N)
This publication has 28 references indexed in Scilit:
- The Effect of Peroxide Cross-Linking on the Properties of Low-Density PolyethyleneJournal of Macromolecular Science, Part B, 2013
- Effect of molecular weight and molecular weight distribution on weld‐line interface in injection‐molded polypropylenePolymer Engineering & Science, 2013
- Mechanism of Peroxide Cross‐Linking of EPDM RubberMacromolecular Symposia, 2010
- Mechanism for Peroxide Cross-Linking of EPDM Rubber from MAS 13C NMR SpectroscopyMacromolecules, 2009
- Adhesion of polymersProgress in Polymer Science, 2009
- Studies on the influence of structurally different peroxides in polypropylene/ethylene alpha olefin thermoplastic vulcanizates (TPVs)Express Polymer Letters, 2008
- Influence of Various Peroxides in PP/EPDM Thermoplastic Vulcanizates at Varied Blend RatiosJournal of Elastomers & Plastics, 2006
- Crosslinking of high‐density polyethylene in the presence of organic peroxidesJournal of Applied Polymer Science, 2004
- Radical reactions on polypropylene in the solid stateProgress in Polymer Science, 2002
- Peroxide Vulcanization of ElastomersRubber Chemistry and Technology, 2001