Control Strategies for the Identification and Reduction of Cogging Torque in PM Motors
Authors:
- 1 September 2019
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 74-80
Abstract
In this work two different methods for the identification of the cogging torque in three-phase Permanent Magnet (PM) motors are presented. The cogging torque map carried out from these methods is then used in a Field Oriented Control (FOC) algorithm to mitigate the ripple in speed and torque. The first method uses a high bandwidth position control loop in a FOC structure, in which a slow and accurate positioning of the rotor is implemented and the cogging torque map is extracted from the q-axis current. Second method uses Load Torque Observer (LTO), which is able to observe various disturbances like load, friction but also the cogging torque. These two methods are experimentally verified and compared. After having identified the most significant harmonics in the cogging torque waveform, they have been suitably added to the q-axis current reference of a FOC in order to mitigate the ripple in torque and speed caused by cogging torque. The effectiveness of the cogging torque reduction algorithm was experimentally verified by significant minimization of the speed ripple.Keywords
This publication has 13 references indexed in Scilit:
- Observer-Based Rejection of Cogging Torque Disturbance for Permanent Magnet MotorsApplied Sciences, 2017
- Analysis of vibration induced by cogging torque in permanent-magnet synchronous motors2017
- Anticogging: Torque ripple suppression, modeling, and parameter selectionThe International Journal of Robotics Research, 2015
- Comparison of Analytical Models of Cogging Torque in Surface-Mounted PM MachinesIEEE Transactions on Industrial Electronics, 2012
- Reference frame approach for torque ripple minimization of BLDCM over wide speed range including cogging torque2002
- Design techniques for reducing the cogging torque in surface-mounted PM motorsIEEE Transactions on Industry Applications, 2002
- Influence of design parameters on cogging torque in permanent magnet machinesIEEE Transactions on Energy Conversion, 2000
- Modeling, identification, and compensation of pulsating torque in permanent magnet AC motorsIEEE Transactions on Industrial Electronics, 1998
- Identification and compensation of torque ripple in high-precision permanent magnet motor drivesIEEE Transactions on Industrial Electronics, 1996
- Reduction of cogging torque in permanent magnet motorsIEEE Transactions on Magnetics, 1988