Air-clad photonic lanterns: fabrication and applications
- 20 April 2022
- journal article
- research article
- Published by IOP Publishing in Journal of Optics
- Vol. 24 (5) , 054011
Abstract
The fabrication steps for an air-clad photonic lantern that can excite the first two LP mode groups in a multimode fiber are presented in this paper. A multiplexing crosstalk below −16.8 dB is measured on the fabricated lantern using S 2 imaging technique over a wavelength of 1525–1575 nm. The de-multiplexing crosstalk is measured for both LP 01 and LP 11 mode groups as −16.8 dB and −9.4 dB respectively using loss measurements. 2 × 40 Gbs −1 MIMO-less mode division multiplexing (MDM) transmission through 7 m of two mode step index fiber is demonstrated using the fabricated photonic lanterns. 2 × 10 Gbs −1 MIMO-less MDM transmission through 1.6 km standard 50/125 µ m multimode fiber is also demonstrated and a Q value higher than 3.7 is obtained for both spatial channels over all input polarizations. Simple intensity modulation and direct detection schemes are used for these MDM transmissions.Keywords
This publication has 15 references indexed in Scilit:
- Polarization Dependence of Mode-Group Selective Air-Clad Photonic Lantern2019
- In Memory of Charles Kao KuenJournal of Optical Communications and Networking, 2018
- 4 $\times $ 10-Gb/s MIMO-Free Polarization and Mode Group Multiplexing for Data Center ApplicationsIEEE Photonics Technology Letters, 2017
- Adiabatically-tapered fiber mode multiplexersOptics Express, 2014
- Few Mode Transmission Fiber With Low DGD, Low Mode Coupling, and Low LossJournal of Lightwave Technology, 2012
- Two mode transmission at 2x100Gb/s, over 40km-long prototype few-mode fiber, using LCOS-based programmable mode multiplexer and demultiplexerOptics Express, 2011
- Multi-mode to single-mode conversion in a 61 port Photonic LanternOptics Express, 2010
- Spatially and spectrally resolved imaging of modal content in large-mode-area fibersOptics Express, 2008
- A comparison of wavelength dependent polarization dependent loss measurements in fiber gratingsIEEE Transactions on Instrumentation and Measurement, 2000
- Tapered single-mode fibres and devices. Part 1: Adiabaticity criteriaIEE Proceedings J Optoelectronics, 1991