Continuous Particulate Filter State of Health Monitoring Using Radio Frequency Sensing
- 3 April 2018
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Reliable means for on-board detection of particulate filter failures or malfunctions are needed to meet diagnostics (OBD) requirements. Detecting these failures, which result in tailpipe particulate matter (PM) emissions exceeding the OBD limit, over all operating conditions is challenging. Current approaches employ differential pressure sensors and downstream PM sensors, in combination with particulate filter and engine-out soot models. These conventional monitors typically operate over narrowly-defined time windows and do not provide a direct measure of the filter’s state of health. In contrast, radio frequency (RF) sensors, which transmit a wireless signal through the filter substrate provide a direct means for interrogating the condition of the filter itself. This study investigated the use of RF sensors for the continuous measurement of filter trapping efficiency, which was compared to downstream measurements with an AVL Microsoot Sensor, and a PM sampling probe simulating the geometry and installation configuration of a conventional PM sensor. The study included several particulate filter failure modes, both above and below the OBD threshold. The results confirmed the use of RF sensors to provide a direct and continuous measure of the particulate filter’s state of health over a range of typical in-use operating conditions, thereby significantly increasing the time window over which filter failures may be detected.Keywords
This publication has 25 references indexed in Scilit:
- Characterizing Diesel Particulate Filter Failure During Commercial Fleet Use due to Pinholes, Melting, Cracking, and FoulingEmission Control Science and Technology, 2016
- Ash Transport in Diesel Particle FiltersSAE International Journal of Advances and Current Practices in Mobility, 2012
- Measurement and Prediction of Filtration Efficiency Evolution of Soot Loaded Diesel Particulate FiltersSAE International Journal of Advances and Current Practices in Mobility, 2012
- Ash Effects on Diesel Particulate Filter Pressure Drop Sensitivity to Soot and Implications for Regeneration Frequency and DPF ControlSAE International Journal of Fuels and Lubricants, 2010
- Different Approaches to Soot Estimation as Key Requirement for DPF ApplicationsSAE International Journal of Advances and Current Practices in Mobility, 2009
- Investigation into Different DPF Regeneration Strategies Based on Fuel Economy Using Integrated System SimulationSAE International Journal of Advances and Current Practices in Mobility, 2009
- Detailed Chemical and Physical Characterization of Ash Species in Diesel Exhaust Entering Aftertreatment SystemsSAE International Journal of Advances and Current Practices in Mobility, 2007
- Diagnostics for Diesel Particulate FiltersSAE International Journal of Advances and Current Practices in Mobility, 2004
- Thermal Durability of Wall-Flow Ceramic Diesel Particulate FiltersSAE International Journal of Advances and Current Practices in Mobility, 2001
- Wall-Flow Diesel Particulate Filters—Their Pressure Drop and Collection EfficiencySAE International Journal of Advances and Current Practices in Mobility, 1989