A 13.2-kSPS Data Rate, 5.1-G Ω Input Impedance Read-Out IC for DC Measurements
- 1 January 2025
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 72 (7) , 3163-3175
Abstract
A high input impedance read-out integrated circuit (IC) for DC measurements has been implemented. The proposed read-out IC consists of a capacitively coupled instrumentation amplifier (CCIA) and an incremental delta-sigma ( $\Delta \Sigma )$ analog-to-digital converter (ADC). An impedance boosting technique, combining the conventional positive-feedback loop with a proposed fine current compensation loop (FCCL), is introduced to enhance the input impedance of the CCIA. Additionally, the proposed structure chops the entire signal chain at a global chopping frequency of 13.2 kHz, which is higher than the 1/ $f$ corner frequency of the CCIA’s main amplifier. This approach further increases the input impedance of the CCIA and eliminates the need for RRL and an analog low pass filter (LPF), thereby reducing circuit complexity and area. Local auto-zeroing and correlated double sampling techniques are also used to suppress the offset and 1/ $f$ noise of the read-out IC. The 18-bit ADC operates at a sampling clock of 4 MHz with a third-order cascade of integrators (CoI) digital filter. Implemented in a 0.13 $\mu $ m CMOS process, the prototype chip occupies an area of 3.808 mm $^{2}$ and draws 1.32 mA from a 5 V supply. The input impedance is boosted from 4.4 M $\Omega $ to 5.1 G $\Omega $ , corresponding to an impedance boosting factor of 1153. The measurement results show an input-referred noise of 2.4 $\mu $ V $_{\mathrm{RMS}}$ with a conversion time of 0.076 ms. The input range of the ROIC is 4.8 V and it achieves the Schreier figure of merit of 164.9 dB.Keywords
Funding Information
- Korea Evaluation Institute of Industrial Technology
- Korean Government [Ministry of Trade, Industry and Energy (MOTIE)] (RS-2022-00144290)
- National Research and Development Program through the National Research Foundation of Korea
- Ministry of Science and ICT, South Korea (2020M3H2A1078119)
This publication has 29 references indexed in Scilit:
- A 7-Channel Bio-Signal Analog Front End Employing Single-End Chopping Amplifier Achieving 1.48 NEF2023
- Toward a Gas Sensor Interface Circuit—A ReviewIEEE Sensors Journal, 2022
- Electronic Skin Based on a Cellulose/Carbon Nanotube Fiber Network for Large-Area 3D Touch and Real-Time 3D Surface ScanningACS Applied Materials & Interfaces, 2021
- A 20 μ W, 0.05mm2 Duty-Cycled Resistor and Frequency-Locked-Loop-based Wheatstone Bridge Interface for Low Resistance Sensing Systems2021
- A Power-Efficient Bridge Readout Circuit for Implantable, Wearable, and IoT ApplicationsIEEE Sensors Journal, 2020
- A 14nV/√Hz 14μW Chopper Instrumentation Amplifier with Dynamic Offset Zeroing (DOZ) Technique for Ripple Reduction2019
- Recent progress in flexible pressure sensor arrays: from design to applicationsJournal of Materials Chemistry C, 2018
- Advances of flexible pressure sensors toward artificial intelligence and health care applicationsMaterials Horizons, 2014
- A 1.8 $\mu$W 60 nV$/\surd$Hz Capacitively-Coupled Chopper Instrumentation Amplifier in 65 nm CMOS for Wireless Sensor NodesIEEE Journal of Solid-State Circuits, 2011
- A 12 bit 50 MS/s CMOS Nyquist A/D Converter With a Fully Differential Class-AB Switched Op-AmpIEEE Journal of Solid-State Circuits, 2010