Prediction of Laser Welding Distortion in Cylindrical Shell Structures Using Direct Application of Inherent Strain
Open Access
- 28 February 2024
- journal article
- Published by The Korean Welding and Joining Society in Journal of Welding and Joining
- Vol. 42 (1) , 134-140
Abstract
In this study, a simplified analysis method by directly applying inherent strain (DIS) at integration points to predict welding distortion of cylindrical shell structures was suggested. The 3D thermo-elastoplastic method demands substantial computational time. The strain as direct boundary (SDB) simplified method using virtual temperature encounters challenges in consecutive thermal structural analysis including welding distortion. The suggested method (that is, DIS) offers the advantage of enabling continuous thermal structural analysis after welding distortion analysis, with computational efficiency. To calculate inherent strain, lap laser welding with 2 mm and 2.6 mm SUS304 plates was performed, measuring fusion and heat-affected zone sizes via cross-sectional observations. Using the calculated inherent strain and our suggested direct input method, we conducted welding analysis and welding test on cylindrical shell structures. Comparison of welding distortion under same conditions revealed radial distortion difference within approximately 10%, corresponding with the experimental result and confirming a computational time reduction by over 2,000 times than those of thermo-elastoplastic analysis. Therefore, an efficient and accurate prediction of welding distortion was achievable through the suggested method.Keywords
This publication has 9 references indexed in Scilit:
- Laser Welding Deformation Control of STS304 Cylindrical Steel Sheet StructureJournal of Welding and Joining, 2020
- Prediction of Plate Deformation by Multi-line Heating using SDB MethodJournal of Welding and Joining, 2019
- Prediction of laser welding induced deformation in thin sheets by efficient numerical modelingJournal of Materials Processing Technology, 2016
- Measurement of Welding Residual Stress in a 25-mm Thick Butt Joint using Inherent Strain MethodJournal of Welding and Joining, 2013
- Prediction of welding deformation of hull panel blocks using an advanced inherent strain analysis method considering the heat equivalent layer effectMetals and Materials International, 2011
- A Study on Weldment Boundary Condition for Elasto-Plastic Thermal Distortion Analysis of Large Welded StructuresJournal of Welding and Joining, 2011
- Development of Thermal Distortion Analysis Method on Large Shell Structure Using Inherent Strain as Boundary ConditionJournal of the Society of Naval Architects of Korea, 2008
- Recrystallization in type 304L stainless steel during friction stirringActa Materialia, 2005
- A New Measuring Method of Residual Stresses with the Aid of Finite Element Method and Reliability of Estimated ValuesJournal of the Society of Naval Architects of Japan, 1975