Characterizing the Effect of Shrink Fitting of Stator Housings on Electric Vehicle Performance
- 14 April 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 40 (4) , 2736-2746
Abstract
High performance rotating electric machines are a necessity in the automotive sector. The characteristics of electric steel materials given in the datasheet used in electric machines do not account for the effect of stress due to the manufacturing process. It is possible to account for the effect of stress coming more precisely from stator housings after press and shrink fitting which degrades the loss properties of electrical steel. A process is developed, which includes the development of a test bench for characterizing the magnetic properties of electric steel when put under compressive stress. The proposed hardware setup is a novel test bench capable of achieving high compressive stress up to 60 MPa and for a maximum of 1 kHz fundamental frequency. A modified compressive stress dependent loss model for analyzing impact on the total power loss is proposed. Further, a coupled multiphysics finite element analysis including structural and magnetic analysis to evaluate the machine performance over the entire operating range and vehicle performance over relevant drive cycles for passenger electric vehicles. A 7% increase in total machine losses was found at an average in a WLTC class-3 drive cycle due to shrink and press fitting of the stator housing.Keywords
This publication has 17 references indexed in Scilit:
- A Novel Cost-Effective Magnetic Characterization Tool for Soft Magnetic Materials Used in Electrical MachinesIEEE Transactions on Instrumentation and Measurement, 2021
- Modified-SST for Uniaxial Characterization of Electrical Steel Sheets Under Controlled Induced Voltage and Constant StressIEEE Transactions on Instrumentation and Measurement, 2020
- Effect of mechanical stress on different core loss components along orthogonal directions in electrical steelsElectrical Engineering, 2019
- Influence of the applied elastic tensile and compressive stress on the hysteresis curves of Fe-3%Si non-oriented steelJournal of Magnetism and Magnetic Materials, 2017
- Influence of axial mechanical stress on the magnetic properties of non-oriented electrical steel2016
- Impact of mechanical stress on characteristics of interior permanent magnet synchronous motors2015
- Iron Loss Analysis of Interior Permanent Magnet Synchronous Motors by Considering Mechanical Stress and Deformation of Stators and RotorsIEEE Transactions on Magnetics, 2014
- Evaluation of local residual stress distribution of stator core in a rotating machineElectrical Engineering in Japan, 2012
- Effect of Stress on Switched Reluctance Motors: A Magneto-Elastic Finite-Element Approach Based on Multiscale Constitutive LawsIEEE Transactions on Magnetics, 2011
- Measuring setup for the investigation of the influence of mechanical stresses on magnetic properties of electrical steelJournal of Magnetism and Magnetic Materials, 2003