Experimental Investigation of the Vertical Upward Single- and Two-Phase Flow Pressure Drops Through Gate and Ball Valves
- 4 October 2019
- journal article
- research article
- Published by ASME International in Journal of Fluids Engineering
- Vol. 142 (2)
Abstract
This paper presents an experimental investigation of the pressure drop (DP) through valves in vertical upward flows. Experiments were carried out using a 1¼″ (DN 32) ball and gate valve. Five opening areas have been investigated from fully open to the nearly fully closed valve, using air with a superficial velocity of 0–3.5 m/s and water 0.05–0.91 m/s. These ranges cover single-phase and the bubbly, slug and churn two-phase flow regimes. It was found that for the single-phase flow experiments, the valve coefficient increases with the valve opening and is the same, in both valves, for the openings smaller than 40%. The single-phase pressure drop increases with the liquid flowrate and decreases with the opening area. The two-phase flow pressure drop was found considerably increased by reducing the opening area for both valves. It reaches its maximum values at 20% opening for the ball valve and 19% opening for the gate valve. It was also inferred that at fully opening condition, the two-phase flow multiplier, for both valves, has been found close to unity for most of the tested flow conditions. For 40 and 20% valve openings the two-phase multiplier decreases in the power-law with liquid holdup for the studied flow conditions. Models proposed originally for evaluating the pressure drop through an orifice in single-phase and two-phase flows were also applied and assessed in the present experimental data.Keywords
This publication has 22 references indexed in Scilit:
- Two-phase flow characteristics in multiple orifice valvesExperimental Thermal and Fluid Science, 2010
- Performance test and flow visualization of ball valveExperimental Thermal and Fluid Science, 2007
- Two-phase flow structure close to orifice contractions during horizontal intermittent flowsInternational Communications in Heat and Mass Transfer, 2006
- Control of Volumetric Flow-Rate of Ball Valve Using V-PortJournal of Fluids Engineering, 2004
- Subcooled water critical pressure and critical flow rate in a safety valveInternational Journal of Heat and Mass Transfer, 2001
- Pressure Losses in Globe and Gate Valves during Two-Phase Oil/Water Emulsion FlowIndustrial & Engineering Chemistry Research, 1998
- Liquid flow through safety valves: Diameter ratio effects on discharge coefficients, sizing and stabilityJournal of Loss Prevention in the Process Industries, 1996
- Hydraulic characteristics of a valve in two-phase flowThe Canadian Journal of Chemical Engineering, 1974
- Measurement of Steam Quality in Two-Phase Upflow With Venturimeters and Orifice PlatesJournal of Basic Engineering, 1971
- Metering of Steam-Water Two-Phase Flow by Sharp-Edged OrificesProceedings of the Institution of Mechanical Engineers, 1965